Electronics Forum | Tue Jun 19 10:14:10 EDT 2007 | realchunks
A faster printer..... at less than 14 seconds? I don't think you'll find one. Easier and cheaper to multi-up the board. Another idea is to print a head of time and use magazines to store boards. Most adhesives have huge board life times. An in
Electronics Forum | Thu Sep 27 15:41:47 EDT 2007 | jdengler
Hi George, We use one from Cami Research. It's very easy to use and is run from a PC so you can store a cable test to use later. You can also just learn a known good cable and use that. See http://www.camiresearch.com Good luck, Jerry
Electronics Forum | Fri Apr 25 04:44:56 EDT 2008 | jkhiew
Hi all, I mean after post adhesive oven curing (SMD at bottom side) prior to manual insert of PTH components (top side), what is the recommended storage time prior to wave soldering in order to avoid pin/blow holes and sunken joints issues (pcb asse
Electronics Forum | Tue Aug 12 08:35:28 EDT 2008 | avalancher
Many years ago... my old engineer used a very simple unit bought at Radio Shack. It was a device that they use in door ways to announce someone was entering the store. It used a beam of light and when the board broke that beam, a bell/ring/noise wou
Electronics Forum | Fri Sep 12 08:01:55 EDT 2008 | davef
There is no standard. On the web, you can find shelf life estimates for various types of solderability protection on bare boards. These estimates won't translate directly to the storage of assembled boards, because assembled boards [and the solderabi
Electronics Forum | Tue Oct 14 07:16:41 EDT 2008 | ccouture
I got this thing at a major grocery store called Loblaws. So far I've used it only to test it, and compare it to our $20,000+ solder recovery machine. I just hope my boss doesn't find out about this.
Electronics Forum | Tue Aug 25 10:38:03 EDT 2009 | grahamcooper22
Hi Sergey, Do you know the Moisture Sensitivity Level of the component ? This is normally recorded on the DRY PACK that the device comes in. It is not unusual for a device to POP CORN and still work in test. It depends how much damage there is to th
Electronics Forum | Tue Nov 03 16:55:48 EST 2009 | tstrat
If the contamination came from the SMT process I would have expected it to be present in the joint above the finish. It is isolated to the EN layer in the ENIG finish. We are doing more analysis to determine the number of boards with the contaminatio
Electronics Forum | Mon May 31 04:17:01 EDT 2010 | nizamjhr
Dear All , I have 1 unit of PBI-Dansensor , Model TIA-222 Oxygen Analyzer that have been sitting idle in my store room for quite some time. Now I want to setup this unit but I don't have any manual or wiring diagram for it. Anyone that have any exp
Electronics Forum | Thu Aug 19 10:28:26 EDT 2010 | tpearson
We want to complete an end of life build on a leaded no-clean circuit board assembly. I was asked how long the assembly can be stored for future use. Assume it is in a temperature controlled warehouse. Boards will be placed into individual ESD bags f
