Electronics Forum | Fri Oct 05 16:05:58 EDT 2001 | seand
Hello everyone, Your chief variable here is going to be your epoxy. Different materials react accordingly to various inspection methods but, DEPENDING on your print parameters and material, you may be able to utilize an inline inspection machine.
Electronics Forum | Mon Sep 03 08:56:26 EDT 2001 | henriksn
Hi everyone, I work in a development firm, that has a small prototype department. We have recently invested in a small automatic SMD pick&place machine. When mounting over 100 different components, the machine runs out of feedercapacity, and the res
Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Tue Sep 18 12:05:08 EDT 2001 | jschake
Optimal Print Parameters: I have responded to a similar question in the thread titled �Stencil Printing For 0201 Applications�, posted by markt and will refer you to that for addressing this question. If you seek clarification on any of those point
Electronics Forum | Tue Sep 18 16:48:55 EDT 2001 | jschake
Why do you think that assembling the BGA, QFP, and fine pitch parts will solve your bridging problem? I would think doing this may cause you more grief by having these more massive components being reflowed upside down fall off during the second pas
Electronics Forum | Mon Oct 08 13:34:44 EDT 2001 | mparker
Dream date? Would that be the St. Pauli girl? I like 'em built for comfort! Thanx for the reply. As usual, you are a fount of information and I will be checking the resource you mentioned. I haven't had much direct experience with saponifiers, now
Electronics Forum | Thu Nov 01 10:10:49 EST 2001 | caldon
DAVE- Sorry for the late response.... as I was outta da country fer a bit. Wolfgang has a great point...If your machine has linear scales or encoders and they are dirty (even a spec of dust) this could have a huge impact on the positional data (esp.
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Mon Nov 12 16:14:47 EST 2001 | davef
Yes!!! How can we assemble boards with 20 pitch when we allow 0.008� error to the master art? Excellent question!!! IPC-D-300G has nothing to do with assembler requirements. It is written by and for fabricators, so that they can be comfortable.
Electronics Forum | Tue Dec 11 04:43:35 EST 2001 | maubrey
I am the director of a performance/art group who work with electroacoustic clothing. Esssentially we perform with electronic clothes that make sounds by react with/to the environment. Please take a look mat our web site (complete wi