Electronics Forum | Thu Nov 03 07:47:51 EST 2005 | davef
Get the documents from IPC. Roland Girouard [rgirouard at smtnet.com] is an system admin
Electronics Forum | Fri Nov 04 11:58:14 EST 2005 | pjc
Its an operator dependant system. I've had operators range from 600 to 1,200 CPH.
Electronics Forum | Wed Nov 09 15:21:02 EST 2005 | russ
Forgot to mention that I did search moonmandarkside.com to no avail. what is up with that?
Electronics Forum | Wed Nov 16 10:42:04 EST 2005 | russ
Contact Sensbey, they manufacture dual pot machines and they can give you the run down on your options.
Electronics Forum | Fri Nov 18 09:46:09 EST 2005 | James
Just don't forget to clean the fingers, they will contaminate you Pb-Free pot.
Electronics Forum | Mon Nov 21 14:00:53 EST 2005 | JF
Try Manix inc. I know they Support this Reflow Oven Model.
Electronics Forum | Mon Nov 21 14:50:59 EST 2005 | cyber_wolf
This oven was not designed to support lead free temps. I am sure Manix will tell you the same.
Electronics Forum | Thu Jan 05 12:06:12 EST 2006 | Rob
It wasn't corroding the stencil, it was corroding the cleaning fluid system.
Electronics Forum | Thu Feb 16 11:09:35 EST 2006 | Rich Paulson
I tried this as a demo, sweat like a pig putting this in but my employer didnt like it.
Electronics Forum | Tue Feb 28 16:10:21 EST 2006 | cmiller
We were also using DBA classic and went to Intuitive about 4 months ago. I think it is a good system but it is also a huge difference from DBA. We picked it for a number of reasons but .NET was a major one. To some extent we are still learning it so
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400