Electronics Forum | Tue Oct 16 07:00:06 EDT 2001 | genglish
Hi all, I have a problem and would gratefully take on suggestions, firstly let me explain the situation: We are currently screen printing adhesive, using a method similar to DEKs 'Pump Print', The adhesive we are currently using is supplied from Alp
Electronics Forum | Thu Oct 18 18:37:49 EDT 2001 | davef
You�re correct. Probably every supplier�s product has slightly different cure characteristics. Let me spin this up a little differently � There was a slight imbroglio in my office this morning involving a couple of stalwarts and the last Krispy Kr
Electronics Forum | Thu Oct 18 11:20:21 EDT 2001 | davef
Ooooo, you do have the toys, baybeee!!!! This really is not a good situation. * Leaving this OA flux res on your boards will surely affect the LT performance of your product. * That a rookie found this by noticing solder balls all over the seconda
Electronics Forum | Wed Oct 24 14:06:37 EDT 2001 | mparker
If you let your design team leave things up to chance, chances are something will go wrong. You are right to want to take control rather than be lead down an undesirable path by the fab house. Various masks serve certain desirable purposes. You need
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Fri Oct 26 11:34:44 EDT 2001 | pteerink
Paul, Many variables that affect changeover, here's a few to start with: 1) Feeder count- do you have enough feeders to be able to do a complete setup off-line? Take your product that uses the most amount of feeders, and make sure you have at least
Electronics Forum | Fri Nov 09 11:55:49 EST 2001 | mparker
If you are getting solder shorts under a device, how would "hiding" the extra long pad with solder mask help? If the pad can't be seen once the device is in place, it is already "hidden". Getting your customer to redesign the pads may take some time
Electronics Forum | Tue Dec 11 04:43:35 EST 2001 | maubrey
I am the director of a performance/art group who work with electroacoustic clothing. Esssentially we perform with electronic clothes that make sounds by react with/to the environment. Please take a look mat our web site (complete wi
Electronics Forum | Thu Jan 10 06:41:43 EST 2002 | Dreamsniper
Okay, I've read about the pros and cons about solder paste dispensing. Now, I have a Camalot 3800 and I want to experiment about dispensing solder paste. I have a needle gauge of 25GA, 23 and 22. My pcb components are; RC 0603-1812, Size B, C and D
Electronics Forum | Thu Jan 10 22:55:24 EST 2002 | davef
You are sure taking you sweet time getting this thing running. You're getting too much beach time. NOZZLE SELECTION Typically, the only rule of thumb that applies to choosing the correct nozzle ID is that it should be one half of the required dot d