Electronics Forum: tap (Page 1 of 14)

3-Phase Corner-Grounded Delta & GSM

Electronics Forum | Tue Aug 04 14:06:59 EDT 2020 | stephendo

Are you sure it is not a 240V transformer with a center tap? That is how residences are wired. If you use the center tap you get 120V. The other tap to center tap is 120V that is 180 degrees out of phase. So if you use the two outside taps you get 24

Water Soluble Paste

Electronics Forum | Tue Aug 30 08:00:34 EDT 2005 | Rob

Tap water will leave residues, whereas de-mineralised/de-ionized shouldn't.

Water Soluble Paste

Electronics Forum | Wed Aug 31 03:32:05 EDT 2005 | edgetech

Thanks for the input guys. I was thinking the minerals found in tap water may cause the components to short/malfunction

Component Reel leads

Electronics Forum | Mon Jul 26 12:05:44 EDT 2021 | proceng1

> https://tapesplice.com/product-category/leader-tap > e-extenders/ We use these as well.

MyData F-MOT MOVESLOWMOVE HYDRA error

Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv

The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new

Foam in the wash

Electronics Forum | Tue Jun 12 18:48:49 EDT 2007 | mefloump

We seem to have an overwhelming amount of foam produced in the initial rinse portion of our wash (enough to cause it to overflow). We are using an Austin American Hydrojet Mach III Inline Cleaner. To my understanding the first rinse of the boards is

Compressor air line material

Electronics Forum | Sat Jun 23 11:35:58 EDT 2007 | grantp

Hi, Yes, we just built a new plant, and used copper again. The stuff we cut out of the old building was copper, and it was fine without any issues. We lay it on an angle so condensation flows to an end, and can be periodically vented, and we take a

Quad 4C origin unstable

Electronics Forum | Mon Jul 22 04:59:01 EDT 2013 | bobpan

You have 1 of 2 problems. 1. The encoder is losing steps so it has a problem or the glass scale that it reads has something wrong with it....dirt,cracked,etc..... 2. The downward camera is loose or has a problem. With power on move the head to a posi

Feeder Protection Plates on Siplace S20

Electronics Forum | Tue Jun 04 15:26:00 EDT 2002 | ghenning

We got a pair and installed them with little trouble. One hole to drill and tap per side. Activates the e-stop but no message on the HMI.

solder fillet peeling update....

Electronics Forum | Thu Jul 17 11:55:33 EDT 2003 | slthomas

Word. WARN + NAFTA = (outplacement assistance + extended unemployment benefits) * Federal retraining $$ = outta here It's been fun. It's been a tremendous learning experience. It's even been lucrative, to some degree. But, it's also been tapped ou

  1 2 3 4 5 6 7 8 9 10 Next

tap searches for Companies, Equipment, Machines, Suppliers & Information

SMT feeders

High Throughput Reflow Oven
Selective Soldering Nozzles

High Precision Fluid Dispensers
Software for SMT

World's Best Reflow Oven Customizable for Unique Applications
SMT feeders

Wave Soldering 101 Training Course


"Find out how you can receive priority in SMTnet Search with out Sponsor membership."