Electronics Forum | Mon Aug 20 07:31:26 EDT 2007 | dilogic
We have GSM1 running on USOS V1.4.14. Is there a way to change default light levels for PEC (down looking camera) during feeder teach? Whatever I tried, it is always set to some default level... - Dejan
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly
I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t
Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm
Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe
Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm
You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly
That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Mon Dec 12 10:38:01 EST 2022 | poly
Cool, I do exactly that, I teach the bottom left and top right corner as it says... though maybe I should try the other ways. It gives me a totally wrong value.
Electronics Forum | Fri Jan 06 08:28:47 EST 2023 | peterm
That's really up to you and for DTF what bank you're using it in so you can reach the pockets for teaching. Obviously easiest to keep them all the same.