Electronics Forum | Fri Jun 15 13:17:27 EDT 2001 | CPI
Are you exposing so you can solder and SMD component directly to it? If not are there ant vias near by that connect to the area you are trying to expose? If not I have done as Dave suggested using a dremal tool. Messy but it works.
Electronics Forum | Fri Nov 12 17:58:18 EST 1999 | Jason Nipper
I have been actively experimenting with Selective WS pallets fabricated from Delmat. I need feedback from users on life expectancy, demesion constraints relative to warpage or degradation, and any useful info on ways to maximize life and prevention
Electronics Forum | Thu Oct 14 08:05:17 EDT 1999 | JohnW
Dream, Sound's to me like your PCB supplier has process problems, probably outgassing or such from trapped moisture / contaminant's. I thoink it's time you called in your vendor for a chat. JohnW
Electronics Forum | Wed Apr 21 13:21:33 EDT 1999 | Scotty
Does anyone have any experience with soldering 50mil pitch BGA's that have a via in the pad, the size is .012 The via will be masked off on the bottom side of the board. Need to know what precautions or problems if any I might encounter. The process
Electronics Forum | Thu Jan 28 14:10:57 EST 1999 | Tom B
Hello Netters, I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI solder mask
Electronics Forum | Thu Jan 28 15:43:16 EST 1999 | Dave F
| Hello Netters, | | I need some info, Earl or Dave, I have a PCB that exhibits a white layer on solder side. It does not appear to be surface residues (IPA has no effect), but looks like its under solder mask. My first guess is that the LPI solde
Electronics Forum | Thu Jun 04 20:52:57 EDT 1998 | D.Lange
| | I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after a
Electronics Forum | Fri Oct 05 07:31:29 EDT 2001 | furrer
When tenting vias almost a few vias are not covered completly by Solder Mask. Does this one side open vias affect the Immersion Tin Process ? Do we get chemical residues in the vias ?
Electronics Forum | Wed Feb 05 19:43:34 EST 2003 | iman
If by the Powers Ta Be (customer/designer), you can't change the PCB design, negotiate for the PCB fab house, to block the via holes with their (green?) solder mask some customers/designers want to have via holes to be present in the PCB pad, due to
Electronics Forum | Mon Apr 07 21:08:52 EDT 2003 | Satbir
Is this safe to wavesolder the PCB in wave contaning carbon pads for switch or somekind of masking is to be put on that pads.