Electronics Forum | Fri Aug 03 22:36:28 EDT 2001 | mugen
We used Thermal Pads, made of black rubbery material, and sticky on both sides (like x2 side tape), intent is to place in between, BGA/QFP and the PCB board, and reduce the air-gap flow between, the PCB to SMD... air-gap will permit air flow, that i
Electronics Forum | Wed Oct 20 17:22:48 EDT 1999 | Dave F
Dunno about 310M flux, but I share your concerns about CU56. You might rethink your selection of solderability perservative, because Enthone: * CU56 allows one thermal cycle. * CU106A allows three thermal cycles. Good luck Dave F
Electronics Forum | Tue Jun 08 05:02:09 EDT 1999 | Charlie Thornton
Can anyone please help me locate details on maximum allowable temperatures of components when passing through a reflow oven. I think I want the thermal profile for the part, or a source or standard which will allow me to check if I can safely reflo
Electronics Forum | Sat Nov 03 05:41:07 EST 2001 | Ben
Hi Could somesomeone help to let me know can bare PCB (FR4) is damaged by thermal shock? Can difference of CTE from copper or solder to FR4 damage PCB from apply heat too fast? Any specification or standard can i refer? Thank you Ben
Electronics Forum | Mon Nov 12 10:57:36 EST 2001 | emmanuel
We are to use a PBGA 272 and a PBGA 388. Between 500 and 750 thermal shocks (-45�C/+125�C), we have noticed that some cracks appear in the solder joints. According to our component specialists, these cracks are due to the whole design (pcb, component
Electronics Forum | Sat Jan 19 02:29:11 EST 2002 | ianchan
Thanks for the tips... found out the ex-employee guy, had pre-bake conditioning put into the process flow, as this pcb is made of polymide material, that is reputed to have historical patterns in thermal sensitivity. To avoid "thermal damaging" the
Electronics Forum | Tue May 27 10:34:30 EDT 2003 | davef
Much of the ability to survive rework or thermal excursions is dependent upon the fabrication materials. The board qualification criteria under the 55110 was designed around 5 thermal heat cycles. Consider reworking a BGA in this context. BGA i
Electronics Forum | Tue Aug 26 21:20:58 EDT 2003 | iman
You may check with the TDS of respective "active parts" IC manufacturers for their recommended no. of thermal cycles permissible in the reflow process. Last I checked 3 cycles for our RF-apps IC was still allowed. For 48pin-QFPs this can be allowed
Electronics Forum | Thu Aug 21 20:20:21 EDT 2003 | davef
Here's the transaction: http://www.photondynamics.com/pd/pr_1025640041 ... but Photondynamics doesn't talk about a thermal imaging product. On the other hand, nether does ART http://www.art.ca/en/products/products.html We spoke to Jacques LaBell
Electronics Forum | Wed Nov 19 19:28:59 EST 2003 | bwet
We are looking for recommendations on reliability testing (thermal cycling, vibration, etc.) of BGAs AFTER being soldered to a PCB. Are there any standards that include such things as heating cycles (like a minimum of 5,000 cycles), ball-ball leakag
