Electronics Forum: thermal cure benchtop (Page 1 of 13)

High-temperature thermal profiling adhesive

Electronics Forum | Sat Jan 10 10:37:15 EST 2004 | cyber_wolf

We have always had success with light cure adhesives for probe attachment. Try these guys for some samples. http://www.dymax.com

UV Curing Conveyor

Electronics Forum | Mon Sep 22 17:18:23 EDT 2008 | jlawson

Another is Specialty Coating Systems (SCS) Have Benchtop to full higher production inline units

UV Curing Conveyor

Electronics Forum | Mon Sep 22 15:25:37 EDT 2008 | davef

Most of the BIG suppliers of uV materials also offer ovens. Equipment, Assembly, Adhesive, Curing System, uV 1 Integrated Dispensing Solutions, 5311 Derry Ave Building D, Agoura Hills CA 91301; 818-597-4300 F818-597-4301 http://www.dispensinglink.co

Automated or Semi-Automated Thermal Gel Application

Electronics Forum | Wed Oct 16 10:51:35 EDT 2019 | radialvalve

Hi Joe, sorry for the delay in responding to your request, hope it's not too late. There are several questions to be answered before we can guide you to the best solution to meet your Thermal Gel Dispensing Needs. I would like the opportunity to disc

Solder Iron Tips - Acceptable Temp Tolerance?

Electronics Forum | Sun Sep 02 09:06:42 EDT 2018 | davef

Cold resistance between the tip of the tool and the ground reference, tip current leakage, and tip voltage. per ANSI ESD STM 13.1 J-STD-001 Rev G, Appendix “A” Guidelines for Soldering Tools and Equipment: A-2 BENCHTOP AND HAND SOLDERING SYSTEMS Se

Epoxy on bottom of SMT component

Electronics Forum | Wed Nov 28 06:52:33 EST 2007 | davef

So, you're curing glue on a thermal recipe intended for reflow even though your supplier recommends that you cure at 150C, because you want to use paste that isn't necessary.

Conformal Coat peeling

Electronics Forum | Thu Apr 09 18:55:49 EDT 2009 | gregoryyork

seen it many times before when the resist is not cured at manufacturing. get PCB man to check with K type thermal couple that boards ARE in fact cured. this is normally 155C ON board temperture not oven setting Cheers Greg

Dymax vs Humiseal Urethane Confomals.... Anyone?

Electronics Forum | Thu Feb 12 15:32:15 EST 2009 | gtemkin

A few other data points to consider. My experience working with Dymax 984LVF material was that its UV cure must be initiated immediately after coating, otherwise is surface will remain tacky forever, something like a post-it note tackiness, which wi

AVR80 BA conformal coating

Electronics Forum | Wed Mar 04 10:23:03 EST 2015 | rgduval

I haven't used this particular CC, but...found this in their data sheet: "AVR 80 BA Conformal Coating will be touch dry after 15 - 20 minutes at room temperature and does not require a thermal cure. The full properties of the coating will be obtaine

Lab & Low Volume Reflow oven

Electronics Forum | Thu Nov 12 09:32:30 EST 2009 | spitkis2

Take a look at http://www.atco-us.com/products/info/3 . Benchtop version is also available. A full forced convection oven delivers much better thermal uniformity than an IR/forced air combo system. When comparing different ovens, some things to

  1 2 3 4 5 6 7 8 9 10 Next

thermal cure benchtop searches for Companies, Equipment, Machines, Suppliers & Information