Electronics Forum | Fri Sep 18 10:58:04 EDT 2015 | adventurelights
Thanks, have checked the vacuum tube and ribbon cables. They seem to look ok. Theta motor seems to be woking. I'm leaning towards the theta encoder going wanky. Is that possible?
Electronics Forum | Fri May 29 16:14:23 EDT 1998 | Jason Gregory
Thanks for the advice, Steve. Hard-headed people in high-ranking positions spells trouble.
Electronics Forum | Fri Oct 02 15:36:23 EDT 2015 | adventurelights
What calibration needs to be done on the encoder for it to work?
Electronics Forum | Fri Oct 16 08:58:13 EDT 2015 | breatheeasy86
I too have the same issue and doubt. Regards, http://sssjobs.in
Electronics Forum | Fri Oct 16 11:32:03 EDT 2015 | azdback
What is your error code?
Electronics Forum | Wed Sep 16 14:04:33 EDT 2015 | adventurelights
Hi guys, Recently got an error message when initiating hardware on a Mydata TP9-UFP. Message is: Theta/2: Lower end point not repeatable. Reinitiating fails at message. Haven't seen this message before. Any idea what it could be as production is hal
Electronics Forum | Wed Sep 13 11:08:08 EDT 2017 | emeto
Here are the basics for theta issues in teaching: 1. CAD part library should match machine part library orientation. 2. If your placement orientation is correct and your feeding orientation(orientation in your feeder) is correct, there should be no
Electronics Forum | Thu Sep 17 15:06:19 EDT 2015 | alexvolovich
Check the vacuum tube on the Zfi head. Make sure the ty-rap isn't interfering. Then check the ribbon cables.
Electronics Forum | Thu Oct 01 15:25:09 EDT 2015 | adventurelights
Which encoder did you replace? The one sitting on top of the midas shaft and below the small board or the one attached t the motor next to it? I don't even know if the first one is an encoder.
Electronics Forum | Tue Oct 06 15:11:09 EDT 2015 | alexvolovich
From what I remember, the round encoder on top of the Zfi head comes preassembled with the shaft. It's made in Germany. I don't remember the manufacturer, but the name and p/n might be on the label.