Electronics Forum | Mon Jan 31 06:58:27 EST 2005 | Martina
Ciao, i want an opinion: in my factory any people says that it's possible, without problems, to test the vias with the probe! Any suggestion? Any problem if you know? Thanks! Sorry for my bad english, i'm italian! Bye!
Electronics Forum | Mon Jan 31 08:30:41 EST 2005 | davef
Yes, probing via is perfectly acceptable. Via: * Pad diameter is 0.028 inch * Via pitch minimum is 0.50 inch ... all of which is fairly common, even when probing test pads. [Your English is fine, at least as good a half the English speakers here.]
Electronics Forum | Mon Feb 28 11:24:13 EST 2005 | EHess
Still looking for a second source for the Electrovert Econopak II wave solder pump motors, or a place that rebuilds them. anyone? Anyone? Beuhler?
Electronics Forum | Mon Jan 31 14:21:26 EST 2005 | Chunks
Not to put Heraeus down - but we experienced the same thing from time to time. We finally found out it was the humidity in building. The higher humidity would cause the bleed out of this adhesive. We switched to Loctite and the problem went away.
Electronics Forum | Mon Jan 31 14:26:52 EST 2005 | lyrtech
Hi, I'm searching for an alternative to stick feeder and vibratory feeder for SOIC-8 on a FUJI IP-2. Does anyone has a suggestion? Thanks a lot!
Electronics Forum | Tue Feb 01 10:52:22 EST 2005 | bubbacott
Hey Has anyone have Jims' contact information Owner of J & S Insertion and an Amistar Guy. May have a new company name. Thanks Scott
Electronics Forum | Wed Feb 02 08:21:16 EST 2005 | pjc
Here's the last nr. I have for Jim: 847-608-6661. I haven't spoken with Jim in about 2 years.
Electronics Forum | Tue Feb 01 22:10:09 EST 2005 | davef
Try: http://www.gerbergrab.co.uk We have no relationship, nor receive benefit from the company referenced above.
Electronics Forum | Tue Feb 01 22:31:51 EST 2005 | Passerby
I may be wrong, but I think one of smtnet's advertisers have something that does this too.. No idea how good, bad or ugly it is or even if appropriate, but try: http://www.unisoft-cim.com/gerber_connection.htm
Electronics Forum | Wed Jul 06 07:14:46 EDT 2005 | avi
I am working for a software house that offers a tool that does exactly that. in case that your request is still valid, email me to avir@kulmos.com