Electronics Forum | Fri May 06 08:09:15 EDT 2005 | davef
You AOI supplier is probably a good source of information, but probably the best source of information is you. Consider moving your machine and comparing the two locations based on the the products you manufacture?
Electronics Forum | Thu May 05 18:14:11 EDT 2005 | rtorres
Hello we are having a problem with an Unitherm 500 reflow oven from Vitronics. the conveyor is not responding to the system, the speed is out of control, it seems to be alerted. Does any one know what is going on. your help is greatly appreciated. Re
Electronics Forum | Sat May 07 04:28:51 EDT 2005 | grayman
try checking the speed/conveyor driver,encoder,comunication I/O Board system and lastly the program. If the driver is at fault replaced it do not repair it. If software try to load it again but make back up.
Electronics Forum | Mon May 09 08:20:52 EDT 2005 | stepheniii
I am not familiar with these ovens, but most I have seen have an optical emmitter reciever and a some kind of sprocket with holes to measure speed. If there is dust build up on the emmitter or reciever, this can cause the speed to increase because th
Electronics Forum | Fri May 13 18:17:33 EDT 2005 | pde
The encoder is a sealed encoder located on the down stream end of the oven. Call Vitronics / Soltec for tech support. There is a calibration procedure for adjusting the belt speed to compensate for loaded and un loaded conditions. Soltec can give you
Electronics Forum | Fri May 06 10:46:09 EDT 2005 | peterdroy
I have created a zevatech users group to help all of us using these machines, for tweaks and fixes or just locating buying trading selling parts and feeders etc Pete Send emails to the group at zevatech@yahoogroups.ca
Electronics Forum | Mon May 09 08:31:23 EDT 2005 | jdengler
Grayman, You might want to read this paper. http://www.speedlinetech.com/docs/Equipment-Lead-Free-Wavesoldering.pdf Jerry
Electronics Forum | Mon May 09 09:02:17 EDT 2005 | davef
Your 316L stainless steel pot will not contain lead-free solder, over the long term. We'd bet that our solder machine equipment manufacturer will "swap" you a lead-free solder compatable pot for your current pot.
Electronics Forum | Sun May 08 08:53:39 EDT 2005 | smtuser1234
Marcel, If I were you I would call Universal and explain what you are trying to do. What are you trying to do ?
Electronics Forum | Sun May 08 07:09:04 EDT 2005 | Rick Iodice
We are continuing to struggle with voids under BGA's. Our problem are not consistent. some CCA's are perfect but others have pin hole sized voids. Does anyone have any feedback on Indium 92j and how it performs for bga's?