Electronics Forum | Wed Feb 07 23:33:13 EST 2007 | KEN
It's been a while on that platform, but isn't there supposed to be a 0.3mm nozzle compliance when at Z0?
Electronics Forum | Fri Feb 02 10:16:27 EST 2007 | tglenn
IPC standard 2221A for board design specifies that through hole leads shall be mounted such that there is only one lead in any one hole. Does anyone the reasons for this requirement?
Electronics Forum | Fri Feb 02 12:37:11 EST 2007 | kennyg
For pads such as a d-pack... what is the effect on heat dissipation of leaving the unsoldered portion of the pad exposed metal or covering with solder mask? Is there a percentage of heat dissipation that is inhibited by covering with mask?
Electronics Forum | Fri Feb 02 14:40:39 EST 2007 | gregcr
Hi All, Has anyone out there used an Airvac DRS-22 for RoHS rework on lead free BGA's?
Electronics Forum | Fri Feb 02 16:44:57 EST 2007 | russ
preheat unit can is a little underpowered on some heavier assemblies, works foine for low mass .050 and thinnner though and have done some 062 as well Russ
Electronics Forum | Fri Feb 02 18:05:19 EST 2007 | MarinaG
I'm looking for the user manuals and the service manuals, and if it's possible some advice to start, I had just purchased one, but I don't know how to do. Thanks
Electronics Forum | Mon Feb 05 12:11:32 EST 2007 | deltaservices
That is a real classic you bought there, i'll have a look if I have some old manuals.......
Electronics Forum | Mon Feb 05 09:42:21 EST 2007 | George
Hello everybody, What is considered "high frequency" when we talk about possible issues with NO-clean flux residues and product's application? I appreciate your help on this... Have a good one! George
Electronics Forum | Mon Feb 05 11:31:37 EST 2007 | davef
While you're waiting for others to reply, look here: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=19507
Electronics Forum | Mon Feb 05 09:48:51 EST 2007 | George
Good morning, What is considered "high frequency" ,.i.e. Mhz,GHz,etc., when we talk about possible issues with NO-clean flux residues and product's application? I appreciate your help on this... Have a good one! George