Electronics Forum | Thu Dec 31 12:32:29 EST 2009 | vetteboy86
Thank you very much for the input. I figured out my problem to be that once I defined the tray, I did not changeover the table top just as Bob said. I'm good to go now, I think anyways. I was so used to the IQ feeders, changing over the matrix tray
Electronics Forum | Mon Jan 04 16:55:47 EST 2010 | dyoungquist
We use a HEPCO model 3000-2 (hepcoblue.com) to shorten leads on various through hole components before we solder them on a pcb. You will have to verify they have a die that works with your particular LED module. If they do, this is what I would rec
Electronics Forum | Tue Jan 05 17:31:12 EST 2010 | mlerley
Howdy folks! Your friendly neighborhood SMTnet.com programmer here. I've spent the last couple of years adding features and fixing bugs for y'all, and now I need some help. The board attached to this post is an inverter for an LCD display fluoresc
Electronics Forum | Wed Jan 06 09:38:59 EST 2010 | lynn_norman
Via failure could be caused by cracks in the barrel, or thin plating, or fractures in the traces leading to the vias, . X-ray analysis could pick up a fractured trace and cross-sectioning of the vias could pick up the cracks and thin plating. Secon
Electronics Forum | Thu Jan 07 15:28:52 EST 2010 | cbart
did the boards get built by hand or via smt process (through reflow oven)? Someone asked earlier if some one touched up the adjacent joint. The answer to that question is yes. Look at how the solder tails off the smt pad away from that joint! I suspe
Electronics Forum | Fri Feb 26 16:54:45 EST 2010 | davemacnemo
I also am having difficulty generating appropriate text input for our recently acquired Topaz. Previous owner used a big (expensive) piece of Enterprise s/w to get the job done. Where can I get CAD2CAD. Looking on the web yields a lot of viewers and
Electronics Forum | Sun Feb 28 10:32:22 EST 2010 | deltaservices
I have a few customers that started just like you. and now have 5 lines. Where are you located US or Europe. (Topaz software is a lot alike the csm software) Do you have the csm manuall, otherwise i can get you one.
Electronics Forum | Mon Jun 07 15:54:56 EDT 2010 | thanh
ECLIPSE-II After calibration, now i'm having an issue that placement between lazer and camera off about .5mm on the Y mount. if parts go to camera, the placement are good. but parts that placing with lazer it off about .5mm at Y for all rotation. do
Electronics Forum | Wed Jan 06 14:34:20 EST 2010 | ppwlee
Hi, Has anyone have experience with manual soldering iron using automated wire feed? I am looking at poke yoke manual soldering 5 pins LCD and wondering if there are ways to control the volume of the solder applied to the board to minimize missing s
Electronics Forum | Thu Jan 14 15:36:23 EST 2010 | tds
JBC Tools has a wire solder feed solder iron. You can control how much is dispensed to the tip. I have sold several of these to customers soldering wires in to terminals. The hand piece is bigger than the typical solder iron but it beats the alter