Electronics Forum | Tue May 02 16:11:50 EDT 2006 | jdengler
Use the Equipment Mart at left side of this page!
Electronics Forum | Tue May 02 18:51:19 EDT 2006 | jsloot
I guess I should have mentioned before that the machines are a Meridian 1010 and 1020P.
Electronics Forum | Wed May 03 09:22:42 EDT 2006 | Nirmal
maybe 5v fuse already burn and pls check anther fuse also thks
Electronics Forum | Thu May 04 03:29:50 EDT 2006 | Mark Fick
The fuses are ok and problem still exists.
Electronics Forum | Wed May 03 11:17:25 EDT 2006 | aj
Guys, What DFM is standard for Minimum Edge Clearance on a PCB for Fiducials and components? Any advice appreciated. aj...
Electronics Forum | Wed May 03 11:55:59 EDT 2006 | Chunks
IPC or DFM? Most DFMs are controlled by the equipment restrictions which will define this parameter. "Dross is just abused solder"
Electronics Forum | Wed May 03 15:17:38 EDT 2006 | russ
SMEMA standards are 5mm edge clearance
Electronics Forum | Tue May 09 12:39:18 EDT 2006 | JW
To All, Thank you for your replies and opinions, this is helpful! JW
Electronics Forum | Fri May 05 11:53:42 EDT 2006 | gregp
What country are you in?
Electronics Forum | Fri May 05 13:31:13 EDT 2006 | BRIAN
PHILIPS TOPAZ X IS A GOOD MACHINE TO HAVE.