Electronics Forum | Mon May 08 16:01:11 EDT 2000 | John
I was running the conveyor at 3.75 when we started the discussion with Electrovert. Unfortunately, foam fluxing is a fact of life for us. Our products have open contact relays that can become contaminated by spray fluxing. Titration is our only me
Electronics Forum | Mon May 01 17:29:25 EDT 2000 | Joe
Hi, We have a climatic controlled assembly area, with a constant temp of 22 deg C and a relative humidity of 40 - 50 %. What I would like to ask is how should I approach a situation when the humidity starts to decrease to below 40%. The situation I'
Electronics Forum | Fri May 05 05:51:44 EDT 2000 | Joe
Thanks for the info. Our system is capable of holding the set limits, but since breakdowns do happen I am considering what to do. So while everything is running, we have a climatic controlled area. The min. relative humidity of 40% comes from the JE
Electronics Forum | Wed May 03 20:12:48 EDT 2000 | Dave F
Ernie: I'm guessing your question is a bit far a field for us. I�d guess that 70% of us are no-clean with the remainder focusing almost exclusively on cleaning printed circuit boards. So rather than limiting yourself with us, also consider forums a
Electronics Forum | Mon May 01 11:51:24 EDT 2000 | Erhard Hofmann
A while ago I read an article about a machine that can pick up a bulk case and then place components out of it without having to travel to a feeder pick up position in between. I forgot where I read this and who the manufacturer was. Can anyone help
Electronics Forum | Tue May 02 01:55:13 EDT 2000 | Erhard Hofmann
You are right, I am looking for a solution to place small components, 0603, 0805, 0402, and similar. The components will be fed by a vibratory feeder and placed onto trays. This is happening in the comp manufacturing stage and the trays are used as a
Electronics Forum | Tue May 02 21:01:21 EDT 2000 | Stefan Witte
I forgot to mention the mass placement machine from Nitto. The Nitto machine places all components out of bulkfeeders. Plastic tubes are routed above the feeders pick position and into cavities of a template. The template is made for the pattern of t
Electronics Forum | Wed May 03 13:57:20 EDT 2000 | Stefan Witte
Mark, I guess while your machine sits idle, it could do boards. While the machine processes boards it breaks down by a certain percentage rate. I would multiply the placement rate with the idle time, multiplied by uptime divided by hundred. 10.000 (
Electronics Forum | Wed May 03 16:11:07 EDT 2000 | JAX
Jack, No need to get frustrated. There is not an optimization software made that will end up with a program that runs faster than doing the same program manually. There are too many ways to speed up production for the software to consider. Even if it
Electronics Forum | Fri Apr 28 13:23:22 EDT 2000 | Chris McDonald
We have had nsome new products come in that require Bottom side wave soldering (SMT). I have SOIC's 1206, 0805 that are Glued then Wave soldered. I have had trouble with bridging and no-clean residue with these pcbs. I have a Econopak 2 SMT two zone