Electronics Forum | Fri Aug 03 12:24:14 EDT 2001 | hinerman
I can only describe how the Grid Lok handles component variability. The compliant caps have an annular ring that is very soft and can mold to different shapes. If a component shows up where there was no component before, the outside of the cap bend
Electronics Forum | Thu Sep 20 13:28:23 EDT 2001 | ohanlon
Here is how the FormFlex system conforms to component variations. The FormFlex system utilizes an oil chamber that is common to ALL the pins once the system is set. Pushing down one pin will cause the displaced oil to be shared by all the others pins
Electronics Forum | Mon Jul 30 10:44:37 EDT 2001 | hinerman
A few of the more common defects If bridging or insuffienct deposits occur on the printer, one of the first things to check is the tooling. Misplaced hard tooling pins or poorly designed fixtures have a nasty habit of breaking components on side
Electronics Forum | Tue Jul 31 13:55:27 EDT 2001 | mparker
Maintain DI water to 18 Meg Ohms resistivity. You can go down as low as 2 Meg ohms, in a pinch, but I would caution on what type of board you are running if trying to clean on 2 Meg ohm. Anything that is running an RF or high frequency circuit could
Electronics Forum | Wed Aug 22 21:11:38 EDT 2001 | ksfacinelli
We have utilized the ERSA Scope for over one year. Our experience is that it is an excellent product in evaluation of problematic assemblies. It takes a little bit of time getting dialed in on the equipment but once you have it mastered it can see
Electronics Forum | Tue Jul 31 18:49:20 EDT 2001 | arsmoriendi
i have a problem with some units that had one capacitor only soldered in one side, the geometry of the capacitor is 0805, our product during his life suffer a lot of stress (due temperature or vibration), some of those units are already with the cost
Electronics Forum | Tue Jul 31 20:12:01 EDT 2001 | davef
If you've told your experts in Germany and US as little as you've told us, I'm not surprised they don't know dip. Sorry, I just snapped there for a moment. That wasn't politic, was it? Yes, it is possible that the other solder connection on this c
Electronics Forum | Tue Jul 31 22:42:41 EDT 2001 | chip
In the past I have spoken to Multitronics sales reps and looked into the product line. I saw their equipment more suited for a smaller "mom and pop" type shop, I work for a mid size contract house and it wouldn't have come close to meeting my needs.
Electronics Forum | Mon Aug 06 15:54:06 EDT 2001 | Fox
I think that anyone who has any questions about Tyco Electronics' offerings as far as equipment should check out their new web site: automation.tycoelectronics.com One other note about the references to Dynapert equipment and their link to Multitron
Electronics Forum | Wed Aug 01 02:17:00 EDT 2001 | djarvis
Anyone placing micro,mini,midi spring inductors (as can be seen on http://www.coilcraft.com) with an FV7100? I can get the little suckers to "test" all day long, but soon as I go into production mode the vision system rejects around 20%. I've tried c