Electronics Forum | Wed Mar 10 18:35:20 EST 1999 | Earl Moon
| I'm in the process of selecting a medium speed pick & place machine. I need to place a wide range of components from 0805 | chips to a 144 pin MQFP (32mm square 25mil lead spacing). | | Anyway, I'm looking at the Quad QSA-30, the Philips Orion |
Electronics Forum | Tue Mar 09 18:21:37 EST 1999 | Stan Levitsky
We will wave solder a board with SOIC14 and SOIC16 parts on the bottom. It has been difficult to find any specific wave solder process recommendations from manufacturers of the SOICs. The pad geometry utilizes theiving pads on both sides to reduce br
Electronics Forum | Tue Mar 09 14:29:40 EST 1999 | Jason Hall
When a board has loaded into the machine and the fiducials do not line up I have tried to use mark edit to set an offset into the program. I lined up the crosshairs and set the data. For some reason the machine did not accept this info. Does anyone h
Electronics Forum | Mon Mar 08 10:02:11 EST 1999 | Steve Beck
Hello; I am looking for general info on backplane assemblies. Any info would be appreciated, but some of the questions that come to mind include: -What part types other than connectors do backplane cards have on them? SMT? Leaded? Quantity? Is
Electronics Forum | Sat Mar 06 13:52:13 EST 1999 | Earl Moon
Where I'm located, we call it OCC. By any other name would it smell/stink as sweet? I need to know, though it's been overworked, who has experience with OSP and its compatibility with water and IPA no-clean, VOC no-clean, and device adhesives (possi
Electronics Forum | Mon Mar 08 09:23:02 EST 1999 | Dave F
| I need to attach / assemble Flexible circuit onto Rigid PCB without use of any connectors i.e. fingers / tracks of Flexible circuit are to be attached / directly to the fingers of the Rigid Glass Epoxy PCB. | | I need info on the alternate proces
Electronics Forum | Mon Mar 01 23:57:00 EST 1999 | Erhan Kaya
"DIP, VCD" -> "smt secondary" type of process flow. In that case, dispensing becomes a must. Dispensing needs less setup than printing, but takes longer. So, for a prototype manufacturer, dispensing becomes the best choice. Sometimes a machine dispe
Electronics Forum | Tue Mar 02 23:08:54 EST 1999 | Marsellus Wallace
| Hello, | I'm doing some research for a project of mine. | I figured that since you sold things related to soldering, | you might know. | | I am wondering if there are any companies that | you know of that do manual soldering while st
Electronics Forum | Fri Feb 26 14:26:19 EST 1999 | SMTASSY
The registration went great. I especially love the fact that we can see how many hits were done. At the start I was a little afraid of the change because the site was all I wanted it to be at the time but you guys have proven me wrong it could be bet
Electronics Forum | Fri Feb 26 10:37:09 EST 1999 | Dave F
Cunli: So, how does one tell if they've been corrupted or not? Does not having a "head" next to your email address mean something? TTYL Dave F | Dave, | | A few registrations were corrupted so those fewer would have to re-register. Most are fin