Electronics Forum | Fri May 15 21:12:13 EDT 2015 | jlawson
As far as I know is pretty basic and only matches IPN to a feeder , does not offer serialisation of actual parts. For trace this is not accurate ie trace a btach to a work order to couple of PCB not possible. This may have changed in latest JUKI off
Electronics Forum | Fri Apr 17 00:30:18 EDT 2015 | bassguy354
Hello. I'm new to the forum & I apologize in advance if I'm out of bounds with this question, but I am out of options. Due to a computer crash, we have lost our only running copy of UCT-31 to program our Universal 4785 HSP machines. The original inst
Electronics Forum | Fri Apr 17 05:27:44 EDT 2015 | sarason
Michael, My program PCBSynergy can program a Sanyo HSP4797. This would be very close to your machine. If you need some mods to the file for your machine, send a copy of a few HSP4785 files at the email address on my web page I am just releasing an
Electronics Forum | Fri Apr 17 12:09:21 EDT 2015 | ilavu
Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial
Electronics Forum | Wed Apr 22 10:08:52 EDT 2015 | emeto
I assume you are running Lead paste and that is why your parts are moving during reflow. Most probably these caps have leads that are bended in random directions(look at some parts from the bottom and observe how symmetrical the leads are). In additi
Electronics Forum | Wed Apr 22 21:21:06 EDT 2015 | comatose
We see this from time to time. Usually, one of the leads of an electrolytic is attached to a ground plane, and the other to a trace. The ground plane acts as a big heat sink and reflows significantly later than the trace. If you have glue in your li
Electronics Forum | Thu Apr 23 12:22:35 EDT 2015 | ercdave1
Thank you for looking at my post. my problem is this. I have a Conceptronic Mark 111 Reflow oven that randomly turns off zone 4 and stops the conveyor belt. turning the heater and the conveyor off on the software and restarting them gets things ba
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Mon Apr 27 14:39:38 EDT 2015 | davef
Anirudh: When board fabs talk "surface finishing" they're talking about the solderability protection that you'd like on the solderable copper component mounting pads that you laid-out for each component: * Bare copper pads corrode very quickly * Corr
Electronics Forum | Wed Apr 29 05:25:11 EDT 2015 | anirudh_thabjul
thankyou for you answer dude. As you mentioned in your answer that immersion tin finishing gonna cause many problems. So, immersion Tin option is ruled out for my purpose. So, immersion Silver is the option left for my purpose But, I have checked f