Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y
Electronics Forum | Fri Jan 08 08:00:40 EST 2016 | proceng1
We utilize the built in profiling equipment in our reflow ovens. It's somewhat tedious to have the operator stand there and feed the TC wires in as the board progresses through the oven. Otherwise the wires sometimes hang up and the board stops mov
Electronics Forum | Fri Jan 15 17:42:14 EST 2016 | huske
We rarely do profiling so we don't need all the new fancy stuff. But when we do I get a piece of aluminum rod and an empty reel of parts (preferably a 12" reel) fasten the thermocouples and wrap the loose end around the reel. The larger reel gives
Electronics Forum | Sat Jan 09 01:30:36 EST 2016 | junax
Thanks for your input Michael. Basically the boards had been go through from washing and even ionic contamination already. In order to eliminate or detect the flux residues, is there any equipment something like a uv lamp that can detect the flux fro
Electronics Forum | Fri Jan 08 15:56:37 EST 2016 | deanm
We received a contract job that requires a board with a heat sink integrated (glued onto the top layer) and the heat sink needs to be powder coated. So I need a board vendor that can provide: Multilayer board fab, Heat sink fabrication, Powder coat t
Electronics Forum | Tue Jan 12 00:43:20 EST 2016 | jrterry
I am shopping around for a cheap pick and place to do a few small runs of boards, just something to hold me over until I get things lined up to buy a high quality permanent machine. I have come across a few Quad 100s that are ridiculously cheap and
Electronics Forum | Fri Aug 26 22:17:17 EDT 2016 | ttheis
If you are looking at the machines from Burton; I suggest you contact them and ask them questions. I just bought their MPM UP500 printer and despite its many quirks does print well for us at the price they let it go for. Others are right though don't
Electronics Forum | Thu Jan 14 09:25:34 EST 2016 | davef
IPC-A-610F 10.2.6 Laminate Conditions - Depanelization talks to the acceptability of the depanelization criteria for assembled boards. There is no requirement for moisture sealing with epoxy or other material. Basically, the standard requires that th
Electronics Forum | Wed Jan 13 09:32:56 EST 2016 | mario
Hi everyone, I am looking for a distributor for the Folungwin wave machines, we need to buy solder pot heaters part number FL-MD-E-LD-FRG-01 and our canadian distributor only has a few units to sell and the leadtime seems to be around 4 weeks, meanwh
Electronics Forum | Wed Jan 13 13:00:14 EST 2016 | anvil1021
We are experiencing a few issues every now and then with acceptable reflow results? We have changed solder paste, thus reflow profile types and even reflow ovens but we still seem to get some not so good reflow on certain pcbs. We can even take PCBs