Electronics Forum | Tue Oct 06 17:36:20 EDT 2020 | hearsehauler
Have used stencils for low volume paste printing for 18 yrs. New job uses jet printing (MY500). But machine is limited to .33mm dot size. Parts used here have pad sizes that are .25mm or smaller, so paste touches between pads when printed. Thankfully
Electronics Forum | Wed Oct 07 15:23:10 EDT 2020 | spoiltforchoice
MyCronic are literally the only ones in the market, Essemtec do Jet printing but make no attempt to sell it as a full printer replacement in the way MyCronic do. I was told by MyCronic "The MY500's are reducing in numbers now and spares support is co
Electronics Forum | Thu Oct 08 18:52:42 EDT 2020 | neosroger
We are looking to improve our SMT Line; We currently have Quad 4C (P&P) CPH; 3600 Capacity: 68 (std 8mm feeders) Minimum Pitch: 0.635mm(0.025") Could you suggest a reliable new Pick n' Place for better CPH and capacity for a value price? We found
Electronics Forum | Sat Oct 10 12:14:45 EDT 2020 | krishna7185
I woud like to ask is there any command in Alitum Designer 17.0 which will help to group component circuit wise while we provide netlist to pcb from schematic. Actually i have single page schematic with many circuits on it block wise like GPS, RF, Po
Electronics Forum | Fri Oct 23 12:06:50 EDT 2020 | johndep7
We may have resolved this issue (fingers crossed) We had someone come out and they informed us that our refractometer was broken. Our measurement of 13% was actually closer to 18-20%. Since making the adjustments our solder has been running much clea
Electronics Forum | Wed Oct 21 00:37:36 EDT 2020 | gabriel1blue
Has anyone been able to replace or upgrade the floppy drive for this old machines? I tried floppy drive emulator but have not been able to make it work. Floppy drive are old and have many problems anyway and would prefer to change it to something new
Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant
hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2
Electronics Forum | Thu Oct 22 14:44:18 EDT 2020 | greasemonkey
I have recently taken charge of a hesse bondjet BJ820, I have zero experience of bonding before this and to be honest, Im finding it troublesome to say the least!! basically wire keeps snapping. I would like to set the head up from scratch but the ma
Electronics Forum | Sat Oct 24 10:41:40 EDT 2020 | phomann
Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking mot
Electronics Forum | Thu Oct 29 20:12:47 EDT 2020 | stephendo
He has posted the individual episodes online. The most relevant one is here https://www.indium.com/blog/the-return-of-patty-and-the-professor.php In it Pete estimates his line has 95% up-time and everyone agrees. The Professor estimates that it is c