Electronics Forum | Mon Apr 13 23:02:52 EDT 2009 | davef
Use IPC-4552 for your ENIG thickness. Typically, ENIG has nickel deposit with medium [7-9 percent by weight] phosphorus content. That's what fabs do on rigid boards. On a flex with medium-P and IPC-4552 specified ENIG, you could see brittleness and
Electronics Forum | Tue Apr 14 11:43:30 EDT 2009 | rmitchell
Hi, We are considering adding on to our SMT line. Our current line is CP65, IP3 and we would like better placement on our 0402's and 0201's. We were looking at the NXT, we would need larger pcb table to match our other machines. We probably only nee
Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Fri Apr 17 10:44:29 EDT 2009 | rmitchell
Hi, follow up, Thanks to everyone that responded. We finished the build, the sun burst thru the clouds and the birds sang. Well that was a slight exageration. Sorry for lack of detail on the original post, I was frazzled. Since the 0201's were p
Electronics Forum | Wed Apr 22 11:58:16 EDT 2009 | markhoch
Quick Question! We have an assembly that we're building for a customer that will have to be soldered via a Lead-Free Wave Solder. We do not currently have a Lead-Free Wave Solder in house. Does anyone know of a company that may be able to provide thi
Electronics Forum | Thu Apr 23 07:51:45 EDT 2009 | scottp
Every paper I've seen published shows that BGA voids either have no effect or actually give a slight improvement. The one exception are voids with a root cause in bad incoming boards, such as champagne voiding where nearly the entire interface is go
Electronics Forum | Tue Apr 28 08:51:35 EDT 2009 | davef
This is a snip from an ealier post here on SMTnet. Generally, solder pastes are comprised of: 90% solder powder, 5% flux, 4% solvents, and 1% activators [by weight]. Where: * Solder powder, when reflowed, is a metal bonding agent that mechanically
Electronics Forum | Tue Apr 28 21:48:50 EDT 2009 | davef
Confirm the source of the issue. Run a coalescence test on both lots of paste. A simple coalescence test can quickly determine the condition of solder paste after prolonged use. Simply print a small disk [around 4-5mm diameter and 0.2mm thick - a bu
Electronics Forum | Tue Apr 28 22:22:45 EDT 2009 | davef
Eat correctly! Make sure you get your daily dose of fruits and veggies. Take your vitamins and bump up your vitamin C. Get plenty of exercise because exercise helps build your immune system. Walk for at least hour a day, go for a swim, take the stair
Electronics Forum | Wed Apr 29 10:08:52 EDT 2009 | wavemasterlarry
I like to cook my lunch thru the ovens on 2nd shift. just heat it up more than anything else - but it works. I think if you just get the right heat into the food it will kill the bacteria. Now I prefer convection over IR. Call me old fasioned, bu