Electronics Forum | Tue Nov 13 12:02:54 EST 2012 | jaimebc
I'll try swaping cards and see if the problem follows the card. So far, my guess would be the motor going bad. I did change the brushes, X wagon cables and every cable that goes to the midas unit. But that didn't fix it. The problem is that to replac
Electronics Forum | Thu Nov 15 19:56:18 EST 2012 | rgduval
I would have said it sounded like a motor/encoder problem...but, since you found the broken resistor, that was likely the source of your issue. The resistor and capacitor are a filter for the motor, MyData likes to put them on nearly all of the moto
Electronics Forum | Tue Nov 20 19:56:12 EST 2012 | hegemon
In order to be able to do full prototype assembly, you will need to be able to mount and reflow a large number of different devices of differing technology. One part might be a simple QFP, another might be a .4mm pitch uBGA. If you are prototyping a
Electronics Forum | Thu Nov 15 10:19:05 EST 2012 | davidmercader
Hi, We have problems with our wave soldering process. The problem is that during the same assembly, after wave soldering, some pcb’s look not clean and other pcb’s look good. We use lead free SAC305 solder and flammable flux. We think our proces
Electronics Forum | Fri Nov 23 06:34:43 EST 2012 | bandjwet
With all of the various techniques available for LGA rework including but not limited to: Bumping the part using a polyimide stencil http://www.solder.net/products/stencilmate Bumping the part using a metal fixture or http://www.finetech.de/advance
Electronics Forum | Tue Dec 11 12:44:34 EST 2012 | deanm
We recently acquired another machine and am faced with the same issue. We are a low volume/high mix company. I chose to run them in series so I can put the more common parts on the first machine and leave them there and put the parts that change from
Electronics Forum | Mon Dec 03 14:23:31 EST 2012 | davef
Spray area personal protective equipment * Paint spray respirator. * Leather topped shoes with slip resistant soles. * Safety eyeglasses Wave solder area personal protective equipment * Paint spray respirator * Leather topped shoes with slip resista
Electronics Forum | Wed Dec 05 08:49:52 EST 2012 | juggalo
I'd love for safety to be number one around here. I cringe a lot as I walk through our facility, I'm shocked by the things people do without the proper safety equipment. I always go and grab the equipment and bring it to the employee and explain, for
Electronics Forum | Wed Dec 05 09:12:26 EST 2012 | sarason
I have worked construction in both domestic and highrise in the last few years. Not wearing safety gear is an immediately sackable offense. It is not a bad way for it to be. Hard hats are always required on multi-story, steel capped boots are always
Electronics Forum | Thu Dec 06 23:38:40 EST 2012 | sarason
Usually an accident that was perfectly for-seeable, due to a breaking of the rules, or an injury exacerbated by not wearing the appropriate safety gear can kick people along to be sensible. A little pep talk along about doing the right thing after a