Electronics Forum | Wed Jun 24 16:23:29 EDT 1998 | Justin Medernach
| Has anyone had experience with placing BGA on gold plated boards. I thought I read a while ago there was a problem with embrittlment causing cracked joints. If anyone has experience with this your feedback would be great. | Mike Mike, Your concer
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Fri Jul 30 16:41:14 EDT 2004 | Dave
Consider a 6 layer board. The Through via gets drilled from top layer to bottom layer. All 6 layers has the hole drilled in it. A blind via is a via that does not got through the entire 6 layers. It would go from layer 1 to layer 2. or layer 6 to lay
Electronics Forum | Tue Jan 23 11:55:27 EST 2001 | aiscorp
I gather from your question that you might have experienced large scale system implementation problems in the past, or at least fear experiencing it in the future. This is a very valid concern based on the performance of traditional CIM systems. Fo
Electronics Forum | Thu Jun 25 09:53:04 EDT 1998 | Earl Moon
| | Has anyone had experience with placing BGA on gold plated boards. I thought I read a while ago there was a problem with embrittlment causing cracked joints. If anyone has experience with this your feedback would be great. | | Mike | Mike, | You
Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Tue Aug 09 13:51:03 EDT 2005 | patrickbruneel
You can also insert a stainless steel screw the size of the hole in the board before wave soldering, this will prevent the solder from wicking up to the top or close the hole (this is real cheap). I still remember the good old days using toothpicks t
Electronics Forum | Fri Apr 27 08:44:08 EDT 2007 | Brett
For those of you who use via holes as test points, and the via holes must be filled at the wave, is it necessary to have a "dome" on every single test point, or is it sufficient to have the via "filled" with solder? The ICT preson here insists that
Electronics Forum | Tue Sep 14 07:54:05 EDT 2004 | modwyer
Folks, At the moment I bake all BGA that are in unsealed trays, to reduce moisture etc. Is this common practice or are there particular manufacturuers that cause more problems. Also, the tape for BGA tape & reel has a hole in the tape (as is normal
Electronics Forum | Thu Aug 22 22:19:13 EDT 2019 | sssamw
From the picture you present, it is a pin in paste part with pin length 2.2mm (a good length for 1.6mm PCB thickness), and seems the pin tilted and touch on PCB surface, thus causes up-part. Sorry I cannot image pin tilted not before placement but i