Electronics Forum | Fri Nov 06 08:04:25 EST 2009 | martinphill
How to calculate Availability in SMT mcs? IDeal Rated CPH or Machine programming time? Pls send me SMT OEE Calculator
Electronics Forum | Fri Nov 13 13:04:00 EST 2009 | jagadeeshrajagopalan
Normaly we clean using tooth brush with anti grease agent. Most of the time we found the eccentric pins got worn out during HSP feeder maintenance
Electronics Forum | Tue Nov 24 19:17:29 EST 2009 | gregoryyork
It could be that the Sn96 has dissolved the Tin rapidly and gone for the Copper. What dwell times are they using with the irons? Probably better off using a Tin Copper alloy for reduced dissolution worth a try Cheers Greg
Electronics Forum | Thu Dec 10 06:01:22 EST 2009 | gregoryyork
have you checked solder resist cure as this will cause the glue to lose adhesion if not cured correctly especially if dwell time sin the wave are excessive i.e 4-5 seconds cheers Greg York
Electronics Forum | Wed Dec 02 22:29:30 EST 2009 | davef
Give him the whole reel and have him build until he runs out of parts and asks for more. Make him keep track of inventory. Your job is to give him a bad time about too much shrinkage.
Electronics Forum | Fri Jan 08 21:34:44 EST 2010 | isd_jwendell
Not specific to QFP, but I had a run of poorly etched boards. I could see the short using 75X magnification with back lighting, but only some of the time. Nasty little shorts on ~25% of the boards that cost us a boat-load of cash.
Electronics Forum | Mon Jan 11 20:32:44 EST 2010 | cusackmusic
There was a company in Canada that used to buy Quad 100s and make them into custom machines. Does anybody know who they are? I have 2 that have been sitting as backups for a few years. It's time to clean house... Thanks, Jon
Electronics Forum | Thu Jan 28 22:05:26 EST 2010 | GMD
Is anyone using PanaCIM or SMS software, with Panasonic CM602 line configuration? We are looking at both software applications in order to collect real time data, create programs and keep track of inventory.
Electronics Forum | Fri Jan 29 14:53:13 EST 2010 | phase1
We aquired this reflow oven some time ago and finally have the need for it. Anyone who knows how to set up this machine and train an individual would be greatly appreciated. We are located in the Rockville Maryland Area. Power is run to the machine.
Electronics Forum | Fri Feb 05 15:50:34 EST 2010 | davef
Baild1632: We've talked about ultrasonic cleaning of assembled boards here on SMTnet several times. Search the fine Archives to find threads like: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=56105