Electronics Forum | Fri Apr 05 11:34:05 EST 2002 | mzaboogie
Hi Jax, Thanks for the input. I believe that the process at one time was to put the part in just before shipping. There was a problem where some boards shipped without the parts installed. (We do not perform ET on these)As a corrective action, the
Electronics Forum | Thu Apr 11 11:26:34 EDT 2002 | johnw
Dave, I sand corrected since I know you wouldn't steer me wrong...although the lst time I looked at the IPC spec for a solder profiel it was still designed for older generations of paste and were specifically water wash biased although that doesn't c
Electronics Forum | Thu Apr 11 10:14:05 EDT 2002 | BTaylor
We use the ASC vision master 212, our customers wanted a height and volume measurement rather than an inspector doing a visual. We have added this machine to our process, checking height on many preprogrammed locations then this generates a X bar and
Electronics Forum | Sat May 04 21:02:26 EDT 2002 | saiwong
I really don't think so. Most of the time copy is much better than the original. For the durabilities, Philips can't compare with the Fuji, Resale vaule, productivities. Fuji is the best. Philips has many original; CD, SACD, Plasma Display. But the J
Electronics Forum | Fri Apr 19 08:19:26 EDT 2002 | jnunns
If the solder balls are next to your discretes, you should consider a homeplate design on you stencil apertures. THe only other time we have seen soler balls is due to the raw card. If the vias are not plugged by the solder mask, solder and air can g
Electronics Forum | Wed Apr 24 07:23:46 EDT 2002 | Vladilslav
Hello! We are using a Triadspectrum (www.triadspectrum.com) TURBOCATS I memory tester, it is good, but we have faced with problems, such as: a poor contact between memory module and test cartridge,absence of the power-on button, every time we need p
Electronics Forum | Wed Apr 24 07:44:35 EDT 2002 | jax
I would check your machine. Often times you purchase IP3's with two different camera's, to accomodate a wider range of components. This might be what you are running into. Questions: What is the size, color, etc.. of your component? Setting for each
Electronics Forum | Tue Jan 28 09:18:51 EST 2003 | bdoyle
I actually removed his other post that was to a four year old thread. Complaints about a company are fine, and in fact we encourage the debates (in a timely manner). However, having an axe to grind...on a four year old thread, will get removed.
Electronics Forum | Mon Apr 29 17:19:34 EDT 2002 | Jimmy
The Agilis feeders perform as advertised after having them in use for several months. They significantly reduce the time it takes to load and unload feeders and don't require maintenance and calibration (unlike traditional feeders and the older Mydat
Electronics Forum | Mon May 13 09:49:18 EDT 2002 | Roger
Is there any difference in performance when running paper tape or plastic? What's the smallest passive component that you have fed in the feeder? How does pressure sensitive adhesive (PSA) tape perform in the feeder? PSA has a tendency to transfer
.gif)
