Electronics Forum | Tue Mar 19 13:25:53 EDT 2024 | jdengler
This was 10 years ago so the results are not valid for todays equipment. I will say that we were surprised at the range of results. We also did not limit it to 3 vendors but did 5. Our priorities were likely different than yours also. In order of
Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Thu Feb 10 22:31:11 EST 2000 | Dave F
CK: If you�ve done everything under the sun process-wise at the wave: different fluxes, more heat, less heat, more contact time, and less contact time; and are running out of ideas; let me table some thoughts. � "Don�t mess with Mother Nature."
Electronics Forum | Tue Nov 14 09:43:10 EST 2000 | jason
Hi, I have a question about charging up batteries. I have two batteries in series, they are NiMH PCB mounted rechargable batteries that are used for battery backups etc. I want to be able to recharge these batteries, so I wont have to buy new ones
Electronics Forum | Thu May 11 21:12:09 EDT 2000 | Dave F
Andy: Welcome. Several points: 1 Be careful in your statistics quoting reverie, particularly on archives use. September was about the time of one of the server upgrades. As part of one of those changes, the previously outstanding, although sadl
Electronics Forum | Wed Feb 07 21:56:00 EST 2001 | davef
Every critter out there with large incisors adapted for gnawing and nibbling has a different theory of solder ball formation. [My theory: It�s punishment for using NC fluxes. Stand and deliver. My solder balls end-up in the gross filter connected
Electronics Forum | Mon Feb 19 13:31:25 EST 2001 | billschreiber
Hello Mark, EPA Certification can be a tremendous help to the user that is evaluating new cleaning processes. Let�s face it, if it wasn�t for the Earth�s ozone layer, everyone would still be using CFCs and a vapor degreaser to clean stencils, PCBs
Electronics Forum | Thu Mar 08 09:38:35 EST 2001 | blnorman
We've been using pre-printed labels on our PCB's for years, with 8 - 10 hours a week down time associated with them. Last October we put a CO2 laser marker on one of our lines. In 6 months we've had a total of 30 minutes down time. We use a 2D b