Electronics Forum | Mon Jun 05 14:08:41 EDT 2000 | Bob Smith
I am trying to find the plastic family used in manufacturing the bodies of integrated circuits. Usually our product is fully encapsulated in ScotchCast however a new application requires part of a pressure sensor chip to be free of encapsulant. The S
Electronics Forum | Tue May 30 08:14:34 EDT 2000 | Aerin Bryson
I had a problem accessing my mail for along time, however, that is resolved now. Now I am having trouble sending email - I sent a test message to an internal smtnet recipient and one to an external recipient and both went OK. Other than that I have
Electronics Forum | Tue May 30 08:07:56 EDT 2000 | David Lazarus
I am a senior industrial engineering student at the University of South Florida. For my Facility Design class, my team has chosen to design a PCA plant that will make one product. We are looking for an obsolete or in-service circuit board assembly
Electronics Forum | Tue May 30 21:06:57 EDT 2000 | Dave F
Thames: Welcome. Consider Rev C. It's current and has "better" descriptions. Consider a course. I believe IPC is doing a tourof A-610 and J-001 classes. Different problems have different root causes. For instance: * Cold solder: Moving the c
Electronics Forum | Wed May 17 13:00:52 EDT 2000 | Mike F
I just wanted to add a comment to the newbies, that dross must be recycled or it is considered a hazardous waste by the EPA. If you recycle it you can avoid a lot of documentation requirements needed for hazardous wastes, but you still need to have d
Electronics Forum | Tue May 16 14:13:50 EDT 2000 | Keith Luke
Due to unforeseen circumstances the May 19th OnBoard Forum with Charles Harper has been postponed until Tuesday, June 6th, from 12 to 5PM Eastern Time. We are sorry for any inconvenience this may cause, and look forward to welcoming SMTneters to our
Electronics Forum | Tue May 16 06:00:47 EDT 2000 | Wolfgang Busko
Do you have influence on the design process ? Avoid components you are not able to assemble in certain $-limits. A way to put delicate parts on the pcb that your P�n�P isn�t able to place is to add an SMD-manipulator used for manual assembly between
Electronics Forum | Wed May 17 11:33:51 EDT 2000 | Michael Parker
Earl- your legacy lives on Dave- About those drinks- Just get me wasted and your halfway there, cuz' if my minds tore up................ I'm in Fremont, where are you? Enough of the nostalgia - it's been a long time since anyone besides my runnin'
Electronics Forum | Wed May 17 14:01:46 EDT 2000 | Earl Moon
Steve, Great to see from you again, as so very many times before? New folks always welcome on the forum. You and Dave are management's big hope for success to attract more advertising. Can't wait to see what you have to ask Mr. Harper, if that happe
Electronics Forum | Sun May 07 14:25:42 EDT 2000 | Jay
I just saw following posting on one of the newsgroups. Any Comments ? AMS is proud to announce 32 bit version of Circuit Creator(tm)- low cost High Performance Electronic CAD software. It consists of Schematic Capture called Logic Creator(tm), PCB