Electronics Forum | Tue Apr 07 22:50:17 EDT 2009 | monduran
Thanks Dave, I found only the speedline discontinued advice link when i first did my search. But your second link answered all the questions. The oven was sold by the time i got around visiting the dealer. I think it sold for $18K AU. I hoped whateve
Electronics Forum | Tue Apr 07 12:47:09 EDT 2009 | rodrigo
Hi All, Our CP6-4000 machine has this weird issue that happens once in a blue moon and only on table two. Lets say it is going to pick up a part from feeder 10. Well, it doesn't stop at the right position. It is slightly off so the thing pushing dow
Electronics Forum | Wed Apr 08 11:33:51 EDT 2009 | 1036
2) STD FR4 material with HASL finish, 4 layer board. Reflowed under tin-lead temps with another 4 layer board same time(no delamination problem). 3) We uasualy do not pre-bake board unless board is too old. 4) We do not have the board on hand right
Electronics Forum | Fri Apr 10 18:51:39 EDT 2009 | boardhouse
Hi Jeff, Your board supplier could be correct in this way. The board could have had just a hair left of copper on the circuit, which would hold up under the electrical test process, but once you powered it up, then there was enough juice to burn th
Electronics Forum | Sat Apr 25 02:46:18 EDT 2009 | smellew
FYI SME offers a replacement Tape leaf detection system which covers the whole range of FUJI CP4-CP7 machines.its also very reasonably priced. It doesn't use Fibre Sensors or mirrors. it only has 1 adjustment which is height via Eccentric screw. even
Electronics Forum | Wed Apr 29 17:51:44 EDT 2009 | smt_guy
One more thing: I have a Panelized PCB with 8 boards on the X directions. As I move to the next PCB towards the right my misalignment moves to the right by 0.02mm. By the time I reach the 8th PCB I'm Off by between 0.12mm to 0.14mm. My fine pitch
Electronics Forum | Thu May 07 17:50:41 EDT 2009 | ecad
Hi, I'm a newbie here but I've lurked about this forum in the past! I'm an experienced PCB Designer I've found myself out of work due to the economy so I'm attempting to start out as a freelancer, I've found that more than a few of the smaller R&D fi
Electronics Forum | Tue May 19 16:33:56 EDT 2009 | stimpk
My 1st question before I can give you an idea or for one even post an idea. Unless I am reading this wrong , you are doing board repair/refurb? You are looking for an inexpensive way to do this repair while at the same time acheieving a proper reflo
Electronics Forum | Fri May 15 15:09:03 EDT 2009 | pcbrookie
We recently added a 7-zone Heller, and have had a 5-zone Heller for quite some time. When the tech installed our new oven, we were told the new oven does NOT have the lifetime warranty on heaters and blowers. However, when we order parts for the ol
Electronics Forum | Thu May 28 12:31:46 EDT 2009 | wrongway
We have universal advantis which us there leser machine I could'nt be happier with it we used to have Amistar machines for ten years it worked ok. but the universal lighting head works great we have had our machines for about 2 years now with very li