Electronics Forum | Thu Apr 07 14:11:33 EDT 2022 | SMTA-69080803
@Stephen How big was the adapter board? It's challenging to depanelize and tedious to manually put these tiny assemblies in a tray.
Electronics Forum | Tue Oct 22 17:23:35 EDT 2002 | Yannick
Hi, I wondering if someone know the anwser to that. I'm using a solder paste 63/37 and on the solder joint we have a tiny little layer or flux who is like crystalin. I try to play with my profile the get it off but I don't get much success. So D
Electronics Forum | Sat Jul 29 09:10:16 EDT 2006 | davef
Ball Grid Array (BGA). A surface mount technology leadless package with the connectors to the board placed in an array on the bottom of the package. They are attached to the board with tiny balls of solder placed on each contact. Pin Grid Array (P
Electronics Forum | Thu Mar 25 09:38:36 EDT 2021 | spoiltforchoice
Well everything Graham said with some additional points.. You mention manual printing but very little about your stencil or setup. Everything you have said indicates a very limited budget has been expended, however what you have is an extreme exampl
Electronics Forum | Mon Oct 15 10:51:49 EDT 2001 | davef
On over printing, the general issues are: * Paste deposits being so large that when reflowing, collapse onto many, rather than a single solder mass. * Paste expanding during heating and being close to other solder deposits and bridging [as you say].
Electronics Forum | Tue Apr 03 01:37:54 EDT 2001 | philipreyes
60% 36% 0f ball area >36% Class2 Accept Reject 45% of ball diameter >45% 20.25% of ball area >20.25% Class3 Accept
Electronics Forum | Fri Oct 12 09:17:12 EDT 2001 | mikecampbell
Hello, I need some advice. I want to create apertures in my stencil for a IBM CCGA. I've heard the standard is 4800 cubic mils of paste per aperture. I usually use a 5mil stencil for this type of product. There is no way I'll get enough paste wit
Electronics Forum | Tue Aug 28 11:12:23 EDT 2007 | grics
This is what I was thinking, but I am being beat up pretty badly by the selective solder. Ambient temperature is anywhere in the the neighborhood of 76 - 80 degrees F. I am not sure of the RH, but I wouldn't think that would be my issue... One of
Electronics Forum | Tue Sep 18 11:34:36 EDT 2001 | jschake
The tightest spacing between neighboring 0201 components assembled was 8-mils. Please refer to the response for the query entitled �Minimizing Tombstoning Defects� posted by martys, as the response provided there is also relevant to address this que
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
