Electronics Forum | Sat Dec 16 09:42:41 EST 2006 | Frank
Hi all, Having been designing (3d modelling and programming) stencils and tooling (solderwave carriers,print support etc) for several years I am now investigating whether it would be possible to do this from home. I live in the UK and am therefo
Electronics Forum | Mon Apr 12 16:38:07 EDT 1999 | D. Lange
I have one assembly needing amp Z-Pack connectors installed (106509-1 & 106510-1). They require very expensive tooling part numbers for tooling are as follows: Bench model (SM-3, 814700-2) or Hydraulic floor model (SM-10/20 803880-6). Each re
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
Electronics Forum | Wed Apr 26 16:18:45 EDT 2023 | cyber_wolf
What model MPM ?
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Wed Apr 26 11:26:03 EDT 2023 | proceng1
Are you looking to make a carrier fixture? Something for the board to sit on that rides the belt? Or do you mean table supports?
Electronics Forum | Wed Apr 26 18:35:07 EDT 2023 | poly
I'm looking to make a board support table fixture that is connected to the printer and uses the vacuum manifold of the printer. Printer is an mpm Accela
Electronics Forum | Wed Apr 26 19:46:57 EDT 2023 | poly
Thanks for the info! If I machine something up I'll put the files up in case anyone else needs them.
Electronics Forum | Wed Apr 26 19:10:43 EDT 2023 | cyber_wolf
This machines support table looks similar to AP and UP machines. I believe MPM published the dimensions of the "H" tower that the dedicated plates bolts to. As far as the plate, they are typically (2) pieces with the inside hollowed out to allow for
Electronics Forum | Fri Mar 24 03:32:05 EST 2006 | ericcyc8
Kindly advise whether we can use tooling holes if there is no fiducials point on the PCB. Is there any others thing that can use, because tooling holes have it tolerances .
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)