Electronics Forum | Thu May 25 10:58:38 EDT 2006 | barryg
Does anyone out there have much experiance with the testronics bench aoi system? We apperently cannot get a demo and are considering the testronics and a mirtec system. Any other systems out there that are in the 25-60k range you would recommend?
Electronics Forum | Thu May 25 11:04:14 EDT 2006 | Rob
Simple, if you can't get a demo (or choose from a huge number of reference sites)walk away with your cash to someone who can help. Also: Yestech & MVP are pretty good.
Electronics Forum | Thu May 25 11:09:58 EDT 2006 | John S.
This is a very competitive market segment. We setup 3 of them side by side at the same time on a demo basis in our facility. Work with them as much as you can, and setup an objective test of their capabilities. Good luck. John S.
Electronics Forum | Fri May 26 08:37:07 EDT 2006 | sant
Hi Kindly have a look into the SAKI's benchtop system. I have not used it.But seen the demo. Different technology.Pretty fast and accurate. Definitley would go with them , when we plan. I would also ask others, if they can provide their opinion on
Electronics Forum | Fri May 26 10:03:13 EDT 2006 | smteng0201
We heard about the Saki systems and did not receive positive feedback. They are quite fast but they miss a lot of easy defects; especially solder ones. Have you checked out a Mirtec system yet?
Electronics Forum | Tue Jun 13 23:16:32 EDT 2006 | mrduckmann2000
WE LOOKED INTO THE YESTECH AND THE MIRTECH. TODAY WE ARE INSTALLING OUR NEW MIRTECH AOI MACHINE. WE CHOSE THIS MACHINE OVER THE YESTECH BECAUSE OF IT'S OFFERINGS. THE YESTECH WAS A CLOSE SECOND. I WILL POST LATER ON THE PROGRAMMING, THEY ARE ALL
Electronics Forum | Mon Jun 26 10:45:59 EDT 2006 | AOI Tech
Yestech,Yestech,Yestech Best friend to those of us in the US!!!!!!!That's all I'm going to say
Electronics Forum | Thu Jun 08 08:55:47 EDT 2006 | russ
Why would a "Wave Master" require an engineer to set up his machine? How could a wave master misunderstand mixing flux types with squirting the same flux on the top of a board? I am losing my confidence in Wave Master Larry! Russ
Electronics Forum | Tue Jun 06 09:20:08 EDT 2006 | Steve Gregory
Hi Vijai, Here's a link to download free clipart of all kinds of SMT packages: http://www.topline.tv/special_offers/TopArtFreeVersion.cfm -Steve Gregory-
Electronics Forum | Tue Jun 20 06:47:53 EDT 2006 | Julien VITTU (STMicro)
hung copper balance is really critical in your case. in the same configuration we have specified less than 5% copper variation between top and bottom layer if you keep this rule, assembly will be ok, otherwise you will get a terrible warpage after