Electronics Forum | Sun Jul 26 22:35:55 EDT 1998 | D.Lange
Masdi, Try board shunts. They are hi-temp rubber strips with grooves cut. They can be popped on and off with ease and are much faster than taping and considerably cheaper. They also work great for masking goldfingers prior to wave soldering. Contac
Electronics Forum | Thu Jul 18 09:55:05 EDT 2002 | gdstanton
Mike, When we measure solder inspection yield by dividing the number of defective joints on a CCA by the total number of joints on the PWB. A defective joint is classified only once. That is we don't count multiple defects on the same joint. Our
Electronics Forum | Sun Dec 22 06:00:54 EST 2002 | Mark
Hi: Your stencil specs are good; Did you check the stencil thickness? It would be worth a ck since there may be an error from the stencil mfr If the paste is not releasing with good stencil specs, these are possible causes: 1 The paste isn't tou
Electronics Forum | Mon Apr 21 17:13:04 EDT 2003 | jonfox
I remember from my days of machine setups that these packages' CAD data is actually off center from where the placement needs to be. Usually CAD center comes up with the parts more to the large collector/ground pad so the the smaller gull wing leads
Electronics Forum | Wed Jul 09 04:57:11 EDT 2003 | Matt Kehoe
Our company applies solid solder to surface mount lands. While processing a micro BGA design we had some pads fall off, peel, whatever you might call it, from the surface of the board when touched "GENTLY" with the tip of a blade to remove a small s
Electronics Forum | Tue Dec 02 11:34:54 EST 2003 | caldon
Adam- I would touch base with the three people I have listed below. Touching base with each one will net you every thing about Vapor Cleaning Equipment you would ever want to know. Ultronix Carl Wolf 800-553-7881 zoc@ultronix.com www.ultronix.com A
Electronics Forum | Wed Mar 02 18:46:02 EST 2005 | Austinj
The tendancy always has been "when in doubt, touch it up"... this is not the way to "verify the process" and is not the best strategy for multiple reasons (unessecary rework, additional labor costs, as well as making the solder joint more brittle, [i
Electronics Forum | Thu Mar 03 09:04:26 EST 2005 | russ
Been following this thread and have a question, Why do "touch-up" people follow different criteria than "Q.C." people. It sounds like the root of the problem is not addressed but bandaids are being put into place. We have no "Q.C." department and
Electronics Forum | Wed Sep 07 10:41:24 EDT 2005 | D.B. Cooper
We've seen the same thing - leads of QFPs not as strong as we'd like them to be. In the past 4 years no problem, this Spring they start failing. Touch a solder iron to it and it solders fine. After crunching some data, we found that both QFPs fail
Electronics Forum | Thu Mar 23 19:46:28 EST 2006 | gipos
Hi Criss, It is Universal 4816 CRS.It have touch screen and "Keypad sound" speaker.Each time you touch the screen it give nice sound.I have tried with universal in EU but still waiting for an answer. It is from ETS.On all the control PCBs it is ETS p