Electronics Forum | Tue Sep 09 08:49:57 EDT 2014 | rgduval
Jorge, If the tooling in question is specific to certain jobs, we'd suggest carrying that tooling on the BOM for that job. Simply assign an internal part number, and assign that part to the BOM. You'll likely have to engrave the p/n or label the t
Electronics Forum | Tue Dec 02 06:07:00 EST 2014 | sarason
A trick I used to use doing RF design was to have on the edge of a panel, a stripline that I could hook up to a Network Analyser to check board impedance. You could do this to verify if the fault is in the no wash process or a board manufacture proce
Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
Electronics Forum | Wed Jul 29 02:20:58 EDT 2015 | nick_arsi
Dear All, Kindly guide me which criteria should follow to do length and impedance matching in PCB layout? Right now I have a design with different type of flip flops, Do I have to length match of data pins of Flip Flops or just rout them as normal si
Electronics Forum | Thu Feb 25 06:55:11 EST 2016 | sarason
Send me a copy of your PADS file with any tracks and polygons deleted and I will have a look at it for you. You may also extract a PCB CSV file from PADS and try that. The FAQ contains what you can use for headings to make the file read easily. rega
Electronics Forum | Tue Dec 27 16:23:03 EST 2016 | sportsradar
Hello Murray, I lost track of your emails. We have emailed a couple of times over the last few months. Do you still have the 80S15 and F3 machines? With the PC and feeders? Please contact me. Thank you. Katrina Sports Radar Ltd Email: trina@sportsrad
Electronics Forum | Tue Jul 19 08:26:46 EDT 2016 | pavel_murtishev
Aleksander, The answer is no. Solder deposit being printed is 80um-150um in height depending on PCB design what is two times higher than any track covered by solder mask. Molten solder will merely center the component. QFNs are prone to soldering
Electronics Forum | Wed Nov 23 14:37:58 EST 2016 | tnisbet
Good day > > I would like to know if the Quad 4C > keeps a register of rejected components in a > certain period of time, like " X components > rejected from feeder Y" or something like > that. > > Thank you so much Adam - The Quad 4C Window
Electronics Forum | Wed Nov 29 21:00:02 EST 2017 | truthseeker
Thx for following up. We have a small PCB in a defense application that has copper sulfide issues. We are using Ion chromotagraphy to track down varions ionic species including sulfates. Your post was a aha moment for me. We have a sample being analy
Electronics Forum | Thu Dec 21 15:35:21 EST 2017 | emeto
For me it looks like a scheduling issue. You can do time studies on your assemblies and predict the best workload, based on scheduling the jobs in the right sequence. Also it sounds like you have only one operator. Train more people to operate will h
