Electronics Forum | Thu Dec 22 10:37:38 EST 2005 | Amol Kane
Hi Steve, We just got the retrofitted machine and i was trained by PVA on Pathmaster. I just wanted to know if many other ppl were using it so i can post any questions/comments on the programming aspect. The coating we will be using is envibar, and
Electronics Forum | Wed Dec 21 06:47:16 EST 2005 | aj
not sure if I am understanding your question ... If the answer to your question is the following , I think you should book yourself onto a Programming Training Course right away! - the x and y co-ords for a matrix tray is usually determind from the
Electronics Forum | Thu Aug 16 14:25:17 EDT 2007 | doug
Hello Angie, Have a look at http://www.focalspot.com... FocalSpot, Inc. is recognized worldwide as a leader in the design and manufacture of affordable high-quality x-ray inspection systems. FocalSpot also sells, reconditions and supports pre-owne
Electronics Forum | Wed Mar 29 08:14:14 EST 2006 | cyber_wolf
Dax, You need to clean out those clutches. Even if they seem OK they can still get varnished up and cause minute alignment problems. I think I mentioned before that you can get in there with a Q-tip, but the true way to get them perfect is to take t
Electronics Forum | Tue Feb 28 07:50:06 EST 2006 | amol_kane
we have used blue and red color solder mask on a trial basis for our LF assemblies. We are performing expts using Imm Sn and Imm Ag to determine the best surface finish. Also, we pass the LF baords thru the same inline wash as you dont wash away the
Electronics Forum | Wed Mar 08 05:17:55 EST 2006 | SAMSUNG user
We have CP60 in the last 2 years, and CP63 1 year. You should check your local C/S about spare part stock, service support, and training for your employees. My conclusion about Samsung Techwin MC's is: cheap, and working well. But dont except too muc
Electronics Forum | Mon Jun 05 14:35:17 EDT 2006 | marc
Yes.... stop checking on your process.... :) Seriously...if you cleaning the boards after I would suspect no issues. If your leaving the flux on the board (I suspect they are using quite a bit) then I would be concerned. Since the boards have al
Electronics Forum | Tue Jul 18 15:47:07 EDT 2006 | Mark
IPC610 training to help verify issues that might arise. Also, the opeators need to know part numbers and descriptions because that should be common knowledge when running a SMT line. Plus, with your comment "At our company they know how the pick&plac
Electronics Forum | Tue Jul 18 19:09:12 EDT 2006 | SWAG
Our lines have operators on all shifts capable of doing programming start-to-finish and can deal with almost any program related problem. We are high mix, low volume. Our builds are sometimes one of a kind with qauntities of 20 or 30. We empower a
Electronics Forum | Sun Aug 13 01:01:12 EDT 2006 | mika
Exactly what type of machines are you gonna have installed, except the Fuji's? Is it all Fuji? This is brand new eq. we are talking about, eeh? What is the delivery time of the machines? When you will go for a bargain, then it should/must include al
