Electronics Forum | Tue Aug 02 11:11:33 EDT 2005 | ianlg
Hi Try Steven at RE-Surface Technologies he has several Nutek ones in stock according to his equipmemt list he just sent me. His e mail address as as follows steven@resurface.com.au (www.resurface.com.au) Regards Ian
Electronics Forum | Mon Aug 08 19:09:20 EDT 2005 | bobpan
why not just try to move the sensors and re-wire the motor to run the opposite direction......i wouldnt think thats toooooo difficult?????
Electronics Forum | Tue Aug 09 12:09:26 EDT 2005 | mtd
I am having reflow issues with small 6 pin SOT's. The joints on these components still look like solder paste after the reflow oven. I have tried adjusting the profile on forced air oven. Any recommendations as what to change in the profile or proces
Electronics Forum | Wed Aug 10 11:41:50 EDT 2005 | tommyttr
Try a Siemens F3, if you can find one. They don't spec 0402's but it can easily place them.
Electronics Forum | Thu Aug 18 10:18:04 EDT 2005 | Allen
I am not sure what their plan is for Europe but can make enquiry. All the Chinese suppliers are trying and will probably adopt an Asian model. That means there will be many points of entry and a few major distributors covering sales and service.
Electronics Forum | Mon Aug 15 15:21:10 EDT 2005 | pjc
Try posting your request in the Equipment Mart section, that's where buyers and sellers post. This is the technical forum, not the sales forum.
Electronics Forum | Thu Aug 25 11:17:56 EDT 2005 | davef
No, but try here: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=35641
Electronics Forum | Mon Sep 19 13:28:52 EDT 2005 | grantp
Hi, Does anyone know if any US company is really good a doing Electroform stencils? We tried DEK out of Singapore, but the lead times were very long. Not sure how DEK in the US is though. Regards, Grant
Electronics Forum | Mon Aug 29 10:33:55 EDT 2005 | SuMoTe
The NMG No Melt is what I currently use. I hadn't thought of replacing it with an oil. Will try it and see how it goes. Thanks for the replies.
Electronics Forum | Thu Sep 01 10:27:16 EDT 2005 | slthomas
OK, then, what's a good book to get that best covers lead free soldering? Is the one I mentioned a good choice? (still trying to figure out why that's such a difficult question)