Electronics Forum | Tue Aug 10 13:16:44 EDT 1999 | ScottM
| Does anyone use reflow profilers? Are they a good investement or is trial and error sufficient? | | Does anyone have any suggestions on profiles to try? Thanks. | | | You need to profile! Some oven manufacturers will try and sell you an ove
Electronics Forum | Tue Aug 10 13:30:29 EDT 1999 | Jeff Armato
| | Does anyone use reflow profilers? Are they a good investement or is trial and error sufficient? | | | | Does anyone have any suggestions on profiles to try? Thanks. | | | | | | | You need to profile! | | Some oven manufacturers will try a
Electronics Forum | Tue Aug 10 05:51:03 EDT 1999 | Gian.D
| | hello to everybody, | | we have a really satisfactory no clean process, both smt/reflow and wave soldering, but we get troubles with defects rework; | | does anybody know how to eliminate flux residues or how not to produce them during rework op
Electronics Forum | Wed Jul 28 12:29:58 EDT 1999 | Jennifer
| Yeh Dan, | Bought one of those DEK/Universal 265's awhile back. Swear it went faster with their name on it. Never done AMI. What's it all about? | Earl Moon Hello Earl! I have spoken to AMI a couple times while trying to do some research on pri
Electronics Forum | Sat Jul 24 23:18:00 EDT 1999 | Scott McKee
| We are going to smt ic's on the component side of our pcb's. | The problem is we are going to have to do this by hand. | We have a hot air station and vac pencil, but How reliable is this process. | We've tried it on proto's and had some shorting p
Electronics Forum | Tue Jul 13 16:44:23 EDT 1999 | Jennifer
| | Does anyone have a US or North American phone and address contact for EKRA (Eduard Kraft)? | | | | I have been told by several people that there is a small office here in the US, but so far I've been unable to locate it. | | | | Any assistanc
Electronics Forum | Wed Jul 14 19:29:15 EDT 1999 | Tony
| | | Does anyone have a US or North American phone and address contact for EKRA (Eduard Kraft)? | | | | | | I have been told by several people that there is a small office here in the US, but so far I've been unable to locate it. | | | | | | Any
Electronics Forum | Mon Jun 14 16:09:15 EDT 1999 | Doug Vaught
| | Anyone know a independent PCB inspection of BGA (X-Ray). We have several test boards that need BGA inspection. | | For detailed analysis try X-Tek in Santa Clara, Ca. | 408/486-9620 | or you can rent the RTX from Glenbrook Technologies for $950
Electronics Forum | Mon May 24 13:06:12 EDT 1999 | Deon Nungaray
| | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcohol, blowing them o
Electronics Forum | Fri May 21 14:22:56 EDT 1999 | Dave F
| Dave, | i tried reflowing bare boards with only solder printed on em and no component placed. we still got voids as same as when components were placed. so atleast one of that theories(voids due to component/component placement)could be considered