Electronics Forum | Fri Apr 22 05:01:19 EDT 2011 | azrina
Hi, I am doing my master degree in flux cleaning process for flip chip assemblies and required to establish a new receipt for flux cleaning. currently, i am doing screening process for the parameters involve ; temp,pressure, surfactants, speed and a
Electronics Forum | Tue Sep 20 11:28:20 EDT 2011 | russw
We've got a Novastar 12S wave solder machine and we've been using Kester 951 flux for years with no problems. We just got a new bottle of 951 and it does not foam correctly (thin foam with lots of large bubbles). After a lot of back and forth with
Electronics Forum | Wed Oct 26 20:20:28 EDT 2011 | machinehead
Our Company is suffering a Huge lose in scrap parts. I recently took over the My12 MyData SMT Machine. And I'm trying to find a remedy to the lose of exposed parts when pulling tape out of feeders. I've tryed alot of things? But still no Luck. I'm lo
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Sat Feb 11 09:58:20 EST 2012 | cbeneat
I have a question for any Panasonic CM 402/602 users. We run Cree XPE/XPG/XPC LED's on our machines, and have struggled for years with the lights sticking in our nozzles. We have two types, I believe both designed by Cree, one picks the light up by
Electronics Forum | Wed Mar 28 09:59:47 EDT 2012 | bradlanger
Sounds like you have tried everything I can think of as far as hardware is concerned. One thing that sounds suspicious to me if the error "Failed to create empty document". I have only seen that error when my MMI software got corrupted in the process
Electronics Forum | Wed Apr 04 15:36:02 EDT 2012 | dynamicsource
Hi guys! I'm sorry if this is out of topic as I don't know or not sure where to post this question. I need help in contacting the management, president, or owner of Viking Electronics of New England as we have been trying to contact the company regar
Electronics Forum | Thu Apr 19 16:08:36 EDT 2012 | rodrigo
Hi all, I'm still trying to get our CP4 to work. I've found 3 relays with bad contacts but replacing them didn't help (weird). I'm trying to check the input lines to the Direct I/O PLC. Could someone take a picture of the LEDs (IN1-3 and OUT1-3) aft
Electronics Forum | Sat Jun 09 10:38:39 EDT 2012 | anton99
Thank you both ( Gnus and Phil) for the replies. I will try to answer both with a new post. I like the idea of the stock room splitting the reels but our reels are released to the floor where the Magload ( Kit building) area stores them and builds t
Electronics Forum | Thu Jun 21 16:30:47 EDT 2012 | grauen06
We are currently using an ACE K.I.S.S. 104. We used SN100 solder with AIM NC265 flux (no clean, alcohol-based). Also, we use topside preheat at 100 degrees C and a 6mm nozzle (as big as we can go with this application). The PCB has a matte finish as