Electronics Forum | Mon Sep 20 11:21:48 EDT 2010 | tony1
I have this NiPdAu small QFN packge sizes less than 2x2. I tried to do solderability Dip And Look test and there's always some units no wet on either ground pad and small I/O. Can someone help to explain why is this so difficult to set on this surfac
Electronics Forum | Mon Sep 20 11:58:22 EDT 2010 | dman97
Hi, I was wondering if anybody knows of a way to close the hood on a 265gsx after it has been opened and the machine has been shut down? What I’m trying to say is that the machine was shut down with the hood raised and the prop rod on. When I boot
Electronics Forum | Mon Sep 20 13:05:05 EDT 2010 | dman97
Hi, Yes I tried to do that. When I stick a key inside the slot, I still get a system suspended error. Although I can press the system switch and I can hear the locks engage, but nothing happens. the machine still thinks the covers are opened and
Electronics Forum | Wed Sep 29 14:19:48 EDT 2010 | davef
In trying to understand your situation better, you say, "The problem is in production. It is difficult to solder SMT package. I was thinking of 1206 package." Please clarify: * What is difficult about hand soldering your SMT part? What is the part
Electronics Forum | Mon Oct 04 15:10:42 EDT 2010 | 18424
Hi Michelle, Due to the dense population of through hole on some boards, after a 35 minute wash, some connectors or battery holders remain wet. Currently we put them into drying ovens at 70c for a Minimum of a half hour. We do occasionally air dry un
Electronics Forum | Thu Oct 07 08:26:24 EDT 2010 | rgduval
According to MyData, you'll need a new computer box. The older computers in the TP's don't support VGA, for some silly reason. So you're stuck with the RGB monitors. I haven't tried, but, I suspect that if you were to get a new(er) video card, ins
Electronics Forum | Tue Nov 02 10:31:22 EDT 2010 | tagge
Hi, we have run in to a tenryu SMT mounter and cant get it going.. When trying to create a program it refuses to set the PCB. The conveyer isnt starting when using PCB SET. Anyone out there who has used these machines? what am I doing wrong? The mach
Electronics Forum | Tue Dec 07 04:23:27 EST 2010 | Jacki
Dear All I hope I can get some advice of PCB experts in here.My problem is - after wave, our big board, 640x420x1.7mm, had a warpage when the board was cooled down after wave. PCB was flat while being warm.I had tried with many type of pallet and mad
Electronics Forum | Tue Dec 21 17:56:13 EST 2010 | stepheniii
Am I reading your post correctly? You will print PCBs and not populate them until up to 24 hours later? And you can assemble level 3 components at 30C and 90% humidity, you just have to pro-rate the exposure time. (I don't recommend having those con
Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if