Electronics Forum | Wed Oct 24 06:02:06 EDT 2018 | vipcircuit
Shenzhen Vip Circuit Co.,Ltd is the professional PCB and PCBA manufacturer in China. 1. PCB business include the general PCB and special process PCB such as HDI, high frequency, aluminum base, heavy copper, golden finger, blind via, flex or rigid-fle
Electronics Forum | Fri Aug 19 08:00:13 EDT 2016 | eplankey
I’ve been tasked with acquiring both pricing and specification information on potential X-Ray units. If possible I would like to gather information on both low-end and high-end units. Here is some information on our facility. I have been to facili
Electronics Forum | Tue Sep 13 19:06:49 EDT 2016 | dontfeedphils
Well I've tried to get in touch with Ovation for weeks now without luck, so maybe someone here will have the answers I'm looking for. One of our Grid-Lok Gold modules is leaking air from the sides (it pushes the pins up fine, but when air is applied
Electronics Forum | Sat Nov 05 20:18:13 EDT 2016 | sarason
I checked the spec sheet and it gives pressure and no volume. The volume on one of my older Yamaha's was about 2.7 CFM. That corresponds roughly to the volume of a small 2HP compressor at your local hardware store. You can place on of these in a smal
Electronics Forum | Sat Oct 22 13:37:46 EDT 2016 | greglac
I am currently working on a custom IC where we plan on using Cu pillars at 80um pitch. I'm am trying to narrow down a packaging solution. My requirements are as follows: 40um Line Width/Space Capability (or finer) 4 layers low loss at mm-wave
Electronics Forum | Fri Oct 28 13:58:57 EDT 2016 | ttheis
Hi everyone, We just picked up an old VIP70 oven and it is in need of more maintenance than we were told when we bought it so I'm working on a few issues. The main thing right now is linking the FCU controller to the PC. I've tried using both seria
Electronics Forum | Tue Nov 15 07:40:13 EST 2016 | robl
1) Look at who is actually franchised to sell the manufacturer in your region, cross check with MFG website. You can buy non-franchised, but if something goes wrong don't expect the local guys to help. 2) Do your engineers/customers need technical s
Electronics Forum | Sat Nov 19 03:15:39 EST 2016 | sarason
Does the file come off of an ICT. Next question is it an AGinet/HP/Keysight 3070. If so you have a chance at finding out the format. It is probably posted online in the Keysight manual downloads section. I might still have an old paper copy of this
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th