Electronics Forum | Wed Nov 14 19:33:20 EST 2018 | reckless
When trying to save a program onto a floppy disk I get this error on the screen. The file was being continuously saved on HD but when I tried saving on the floppy as a backup all data was lost and there was no way to recover original file. What k
Electronics Forum | Mon Apr 22 14:06:25 EDT 2019 | kgarlapa
Yes it is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois. I tried holding the reset/start button and also tried to cycle the power after after holding the reset button, No Luck.Do you know if Kanetic is sti
Electronics Forum | Wed Dec 11 06:29:20 EST 2019 | ameenullakhan
Dear Javi, Thanks for the feedback and review. Sorry i was bit busy. Yes the issue is minimised, but not eliminated. We have tried with reducing the vibration source in chain conveyor of oven. Our board is having parts very next to each other. O
Electronics Forum | Mon Sep 30 09:40:57 EDT 2019 | proceng1
One thought. Since this machine uses the camera as the board sensor, I've had a metal board support right where the camera sets up to detect the incoming board. Try loading the board after removing all the board supports. If it loads, then try som
Electronics Forum | Fri Oct 18 16:40:32 EDT 2019 | tey422
Whenever you are not sure if a part is good or not. Try to use it on the 2nd machine which uses the same part to test it out. If it "test" part works fine on the 2nd machine then it would be ruled out as not the "root cause". In your case, you can t
Electronics Forum | Mon Jan 06 16:19:32 EST 2020 | richardcargill
haven't tried the MINT as it won't let me get that far !! Swapping the Eproms with card 1 and changing the identifier will let it get to the 'Press SYSTEM key' part of the startup though, then it fails on card 1 instead of 0 so I'll give that a try i
Electronics Forum | Wed Jan 15 12:10:22 EST 2020 | emeto
Avillaro, I don't have hands on experience with Vapor Phase equipment, but my guess is that it will work better for thick boards like yours. Trying another chemistry is a logical move. May be it is worth trying the fixture for connector flatness as n
Electronics Forum | Fri Jan 31 10:04:14 EST 2020 | emeto
Jinesh, My initial suggestion is you have too much solder past. Please try to reflow a few of these parts without solder paste. Colse aperture, put some tacky flux on this part location and give it a try. I bet you will not see any voiding.
Electronics Forum | Fri Jan 31 08:45:30 EST 2020 | ilavu
I have one Pemtron SPI TROI-5500H machine and hard drive crash on it. I am trying to get it back up and running. I install the XP and old version of TROI software. Currently i am trying to calibrate the machine and no luck. During the PZT calibration
Electronics Forum | Sun Mar 22 19:33:54 EDT 2020 | kylehunter
> THe Ealead software pretty much does everything > for $1000US, Its big weakness is its importing, > for this you use PCBSynergy. Have you tried the > Ealead demo it run's for a month.But it is > limited to 10 feeders sarason.