Electronics Forum | Thu Sep 02 08:32:18 EDT 2010 | rway
Yes, you are correct. I converted it (tryed to at least) by hand and did not carry by decimal place far enough in converting mm to mil. I double-checked my conversion and confirm 1mm = 40mil. Thanks for correcting me.
Electronics Forum | Mon Aug 16 12:27:44 EDT 2010 | mikesewell
Don't have one but have you tried starting with a fresh install of the software, you may want to swap PCs or hardrives to keep your existing setup intact.
Electronics Forum | Wed Aug 18 13:57:40 EDT 2010 | pfifla1
yes Jeff, i tried that, with the user - administrator but it doesn't work. all the other times i have used the BTUs it has been BMOC.
Electronics Forum | Fri Aug 20 10:11:19 EDT 2010 | namruht
I just found out that we have an older Omron VT-WIN that we are not using. I do not know anything about the machine, but I am curious if it is worth trying to bring onto the production floor and use it for inspection. Can anyone tell me anything abou
Electronics Forum | Sat Sep 18 03:50:23 EDT 2010 | vinitverma
I know of Ambitec (Taiwan). They make feeder calibration jigs where the base is common for all types of feeders. You just need to replace the jig on the base depending on the feeders you're trying to calibrate. They provide base as well as jigs for m
Electronics Forum | Fri Aug 27 20:13:41 EDT 2010 | whitewing
Have you tried replacing the LEDs in the illuminator? This is about the only 'wear' mechanism on a vision system, and should be pretty easy to fix.
Electronics Forum | Wed Sep 01 10:15:44 EDT 2010 | arjan
Dear Sachu_70, During the tests we also checkt other devices, there are a few small voids visible, but they are marginal. We only see large voids in this device. During the testruns we tried several reflow profiles, but without large succes.
Electronics Forum | Tue Sep 14 13:40:50 EDT 2010 | rayguide
SERA testing is the solution. Try it. http://www.suite101.com/content/circuit-board-design-diagram-and-assembly-a249751
Electronics Forum | Thu Sep 02 03:00:59 EDT 2010 | sachu_70
Hi Kevm, would it help to try solderability test of these pads using an agressive flux during soldering? Just a thought.
Electronics Forum | Thu Sep 02 11:45:47 EDT 2010 | kevm
We have tried solderability testing using an agressive flux and have had good results. However, our Mfg process uses laser soldering equipment which is a validated process and we are limited on the type and amount of flux we can use due to ionic cont