Electronics Forum | Wed Nov 05 08:45:13 EST 2003 | Marc V.
I am trying to figure out how many feeders I will need for our first venture into SMT. I have broken down our largest board we would build into the different feeder types. What I need to know is, how many extra should I order? Why?
Electronics Forum | Tue Dec 02 03:58:11 EST 2003 | ex maintain leader
Sr. Tech, try to find a private spring manufacturer locate in your aera. The asian springs are not long life, no heating schock is done during manufacturing. Panasert and Fuji feeders usual problem each factory I visited. This is a way for you to re
Electronics Forum | Tue Nov 25 13:29:58 EST 2003 | gregp
http://global.ihs.com/ ...is the distributor for EIA standards. It'll cost you about 50 bucks. The standard is EIA-481-B and covers 8mm-200mm embossed tape and 8mm and 12mm punched tape. I tried searching for this standard on this site but the se
Electronics Forum | Wed Nov 26 06:16:38 EST 2003 | stefwitt
Some older test equipment as well as older Siemens machines use HP Basic as an operating system. HP does no longer manufacture the hardware (300 family computer) which required HP Basic as an operating language. Did anyone of you tried to change the
Electronics Forum | Wed Dec 10 10:44:43 EST 2003 | RicardoF
I agree with all the comments saying MPM and DEK are OK, but more that spent those $90 KUSD in the machine, consider also the operating costs, spares, service, etc. We have had sometimes poor response to our MPM in the Mexico Plants. Try the EKRA if
Electronics Forum | Wed Dec 17 14:38:25 EST 2003 | davef
Francois Monette [Cogiscan Inc. 450-534-2644 fmonette@cogiscan.com ] is the resident genius on component and board baking. If he doesn't chime-in a in a day or so, give him a shout. He seems to nap quite a bit. Alternately, if you search on his na
Electronics Forum | Mon Dec 22 18:08:38 EST 2003 | Tom B
Dave is absolutely right! A question is there free standing DI water left on Parts after wash and rinse, if so this can definetly exacerbate the problem. You can try to remove excess DI water by using an IONIZER air source to blow off any water. S
Electronics Forum | Tue Jan 20 17:48:45 EST 2004 | Brian W.
Photon Dynamics is out of the X-Ray business. Try Yestech. They have a number of former CRT and Photon people. Had a similar problem with a CRT 2000 one time. You have to replace both the tube and controller. If I remember correctly, they are m
Electronics Forum | Wed Jan 07 13:17:56 EST 2004 | James
We currently have 2 HVA 102 conceptronic reflow ovens. I ran 2 profiles on the 2 seperate machines. One of the oven ran 7 degrees lower than the other oven. I checked all the fans and they seem to running fine. I get no warning on the monitors.
Electronics Forum | Tue Jan 13 22:43:11 EST 2004 | davef
We have seen this in reflowed parts, where there is flux res collected in the dimple in the solder, where the lead 'presses' in the solder. Generally, we attack this as a thermal issue: * Thermal pads sucking the heat away from the leads. * Leads no