Electronics Forum | Wed Feb 05 04:37:29 EST 2014 | pavel_murtishev
Mr. Evtimov, Could you please tell me what X-Ray focus is? Machines runs auto-focus routine each time when swithched on showing green/grey/black dots and trying to find centre. What is it for? What is machine searching and how? Thank you.
Electronics Forum | Sun Feb 09 19:16:22 EST 2014 | navworx
Was running production when the head just came to a stop, motor went off, error window said to home. Upon attempting to home, got message: G1T2 homing error; index mark not found. I've tried rebooting the machine, but this error still appears. Any
Electronics Forum | Thu Feb 27 15:21:37 EST 2014 | idscraigsmith
My company uses a Juki KE-2020L and a Juki KE-1070L pick and place. I am trying to locate feeder trolley's with feeder banks that would be compatible with these machines but am having a hard time finding anything. Anyone have suggestions of where t
Electronics Forum | Fri Mar 07 15:57:32 EST 2014 | jdengler
We have used the Stencilquik™ BGA Stencils from the same supplier to attach some LGA's for a prototype run. We were able to get a few different thicknesses to see which worked best. They worked very well for that limited application. We did not tr
Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss
Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c
Electronics Forum | Sat Mar 29 10:04:03 EDT 2014 | josse
Hello there everyone! Our company just bought an AOI Inspection Machine, and that is the Mirtec MV-2HTL 1.3 megapixel, software rev 4. I am trying to create a program that runs the top side first and then asks to run the bottom side consecutively. I
Electronics Forum | Thu Apr 17 07:51:19 EDT 2014 | emeto
Opens are on the device to the PCB - mainly on the edges, that makes me think I get some kind of warping,but even if I bake parts and boards doesn't help. We also tried different reflow profiles - same results. I hear that some people use dip fluxers
Electronics Forum | Mon Apr 21 16:38:45 EDT 2014 | barryg
Hello all. We have been having some problems soldering to what we believe is a nickel plated spring steel battery terminal to a PCB. We have tried scrapping , then tinning, dipping and still have problems. Are there any special fluxes or pre-treats t
Electronics Forum | Thu Jun 05 16:58:16 EDT 2014 | proy
I would love to use my old zevatech with a large nozzle (qfp) to pick kapton masking dots and place them on a board. I am getting some 'thicker' kapton dots to test, and need to find a way to present them, might be a trick but worth a try. Has anyon
Electronics Forum | Thu Jun 19 12:18:45 EDT 2014 | haiae
There are two IR sensor (one for tipdown detector and other one for tipup detector) for each tip in each head. You should check infrared sensor for Head2 tip1, that cause may be by dirty between IR emitter and IR receiver. Just clean it and try to ru