Electronics Forum | Sun Oct 25 19:08:44 EDT 2015 | jc_smith
Hi everyone! I'm needing a 4 layer board for a DIY project. A friend recommended me to try with PCB Unlimited, since they are giving to students a professional stainless steel stencil for free with buying one of their PCB panel share. Has anyone prov
Electronics Forum | Thu Dec 03 15:34:57 EST 2015 | proceng1
Superior 420-XF-LF is what we use. When we switched, it took some time of just running it through the stone before we got the optimal performance. Especially when going into the clean and dry tank on monday morning, we usually let the fluxer run for
Electronics Forum | Sun Nov 22 18:03:38 EST 2015 | ttheis
Hi Deni- Thanks for the reply. I'll try to figure out what vision system is on it. I know it has two 5.3mil cameras front and back, UPS 3.2.2c os/2. Where do I determine the type of vision system; in the computer or harware spec plate?
Electronics Forum | Tue Dec 01 23:22:23 EST 2015 | ttheis
Swapped the EXM-13A with no change; going to try the EXM-14 card next. Do the monitors split from one VGA port via a cable splitter? I'm still working on getting manuals for this machine so I'm learning as I go so far, thanks for the help.
Electronics Forum | Fri Nov 20 23:22:52 EST 2015 | rx8pilot
Hello, I am trying to figure out if it is possible to program the index distance on Quad Tyco Feeders. I recently got a Quad IV-C and on the 16mm feeders, they index 12mm where I have an 8mm pitch tape. It is a non-IQ machine so I am looking an man
Electronics Forum | Mon Dec 07 13:24:12 EST 2015 | futureretro
Recently purchased a used Samsung CP20CV, and am trying to locate the operation manual. Please contact me if you happen to have one for the CP20, CP30, or CP40, any of which should get me going. Talked to Samsung US support and they sent me some li
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Thu Feb 25 06:55:11 EST 2016 | sarason
Send me a copy of your PADS file with any tracks and polygons deleted and I will have a look at it for you. You may also extract a PCB CSV file from PADS and try that. The FAQ contains what you can use for headings to make the file read easily. rega
Electronics Forum | Tue Mar 08 10:23:53 EST 2016 | mnorthey
I am trying to decide how to best dispose of our old running Siemens equipment. I would like to get something for them but I am not sure who needs these older machines I have about 8 available; any ideas guys?
Electronics Forum | Tue Apr 19 10:09:33 EDT 2016 | swag
Try a nozzle changer teach. Machine will look for fids on the changer block. If that doesn't work, clean the rubber seals in the bottom of the block. No alcohol - dries them out. Might need to replace them if they are dry or cracked. Clean your