Electronics Forum | Wed Jun 02 03:32:09 EDT 2004 | Evtimov
It's obvious the problem is in the software. Because they tried to make it user friendly, you can't use the vision system at all. You only choose the type and everything else is done internal. that's why they missed some possibilites.I know mashines
Electronics Forum | Fri May 28 16:58:15 EDT 2004 | Mike Cyr
Hi Jay, You might try calling our technical support team to get you started on sorting out these problems. I am attaching the link to our website and support page and the Email and telephone numbers. If they are unable to help you out, they can ar
Electronics Forum | Tue Jun 01 06:13:11 EDT 2004 | abraham
We have been populating lot of BGA boards and for all these boards we have been using No clean solderpaste. We are under the impression that aqueous cleaning is not recommended for BGA boards as the residue cannot be cleaned properly. However we are
Electronics Forum | Thu Jun 10 16:21:43 EDT 2004 | Charlie
Guy,s I do not have Red-e-set, but Grid-lok offers a fully automatic system that easily installs onto the printers and P&P. It can be set to your board instantly by pressing one button or triggered by the printer to set for each consecutive PCB. They
Electronics Forum | Wed Jun 16 13:25:09 EDT 2004 | russ
have you tried a more agressive flux like water soluble to see if the problem goes away? Or can they be hand soldered with no problem? I am basically out of ideas other than a bad nickel or tin finish. The reflow profile didn't seem out of whack f
Electronics Forum | Wed Jun 30 16:44:27 EDT 2004 | Richard
You could also try using a wire mesh out of stainless steel(won't rust). We used these as reflow baskets and for covering parts for a steam cleaner we had for W/S flux. go to http://www.mcmaster.com and type in *Metal and Thermoplastic Cloth and Perf
Electronics Forum | Thu Jun 24 17:13:44 EDT 2004 | davef
Echoing SheanDalton's comments [above in this thread]: * A good way to strip part markings, solder mask, etc. * A fairly aggressive against most polymers. * A flammable material. * VOC issues in its use. * Assembly workers don't like the smell. * A
Electronics Forum | Thu Jun 24 23:00:36 EDT 2004 | yukim
Tried with several lots of solder paste, manufactured in Feb and March this year. Work ambient: 25C, 60~70%. Is this humidity too much? I'll reduce the ramp in our profile. One change: We changed the conveyor motor in our reflow oven just before the
Electronics Forum | Thu Jun 24 20:14:52 EDT 2004 | Alan
I know your frustration. CP6 feeders are notorious for this issue. They have always been an issue. You have probably went through the "change spring, change tape leaf, change component reel, place peeler tape over two rollers instead of three" scenar
Electronics Forum | Tue Sep 14 04:28:36 EDT 2004 | Rob
Hi Dave, 3M� Spray 75 Repositionable 500 ml was the last we used due to a bright spark in purchasing, but production didn't get on with it too well. The only one that really gives us good consistant performance was the original 400ml Spraymount a
