Electronics Forum | Thu Dec 29 10:47:22 EST 2016 | luciano
Thanks SuMoTe, I've already tried fluxing various boards (new clean ones and older ones) without turning the waves on and with different temperature setups (within the suggested params from Alpha) in the preheat zone. The results were in many cases
Electronics Forum | Fri Feb 10 01:20:17 EST 2017 | bukas
is it yellow dust? if yes, 1. you will probably need to clean whole pot. it sticks to walls of the pot and circulates trough alloy. 2. get your alloy checked, how much of unwanted metals/contaminants it has 3. try alloy refresh bars, there was a po
Electronics Forum | Fri Dec 01 13:55:44 EST 2017 | emeto
Brikainis, it looks like these vias are not plated and closed. I would say that thickness of your paste is lifting the part. Are you willing to try another stencil with ground pad apertures matching the via holes? It is probably worth trying. Anothe
Electronics Forum | Thu Oct 04 15:11:39 EDT 2018 | emeto
1. From your explanation it looks like you need more flux. Try to overprint a little or use 150um thick stencil 2. You should consider a little different profile - probably try to have a soak zone in the right alloy and flux range and give the part t
Electronics Forum | Thu Nov 15 11:03:17 EST 2018 | bobpan
When our older Ekra machines wont reference.....we will either try to e-stop it and then turn the control back on and reference it again....or turn the machine off and back on. I would check all the sensors on the machine and also try to reposition
Electronics Forum | Wed Nov 14 19:33:20 EST 2018 | reckless
When trying to save a program onto a floppy disk I get this error on the screen. The file was being continuously saved on HD but when I tried saving on the floppy as a backup all data was lost and there was no way to recover original file. What k
Electronics Forum | Mon Apr 22 14:06:25 EDT 2019 | kgarlapa
Yes it is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois. I tried holding the reset/start button and also tried to cycle the power after after holding the reset button, No Luck.Do you know if Kanetic is sti
Electronics Forum | Wed Dec 11 06:29:20 EST 2019 | ameenullakhan
Dear Javi, Thanks for the feedback and review. Sorry i was bit busy. Yes the issue is minimised, but not eliminated. We have tried with reducing the vibration source in chain conveyor of oven. Our board is having parts very next to each other. O
Electronics Forum | Mon Sep 30 09:40:57 EDT 2019 | proceng1
One thought. Since this machine uses the camera as the board sensor, I've had a metal board support right where the camera sets up to detect the incoming board. Try loading the board after removing all the board supports. If it loads, then try som
Electronics Forum | Fri Oct 18 16:40:32 EDT 2019 | tey422
Whenever you are not sure if a part is good or not. Try to use it on the 2nd machine which uses the same part to test it out. If it "test" part works fine on the 2nd machine then it would be ruled out as not the "root cause". In your case, you can t