Electronics Forum | Wed Jan 06 04:43:22 EST 2010 | deltaservices
If you are working smt machines in Europe or US then your most important issue is setup time and operators needed to run the machine. People are way more expensive then machines. I know the assembleon machines, Gem line and the new MG lines are grea
Electronics Forum | Mon Jun 29 15:45:20 EDT 2020 | spoiltforchoice
Yeah my issue with the CLM945 type single slot feeders used for parts over 6mm is they index forwards using a tiny servo attached to some gears that pull on the cover tape. A system that begs to fail, the tape can stretch, the gears can start grabbin
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Wed Jul 16 05:16:49 EDT 2014 | spoiltforchoice
This number is going to vary hugely depending on the machine, how you operate and how many feeders you have. Smaller outfits might have a single operative whose job it is to setup, load, run & program the line. Regardless of how changeover focused t
Electronics Forum | Wed Oct 03 23:59:44 EDT 2018 | gaintstar
Flason SMT problem solving: http://www.flason-smt.com/new/PRINCIPLE-OF-SURFACE-MOUNT-PROCESS-SMT-PROCESS.html http://www.flason-smt.com/new/Printed-Circuit-Board-PCB-Price-Estimator.html http://www.flason-smt.com/new/Printed-Circuit-Board-Solder-res
| 1 |
