Electronics Forum | Thu Dec 17 16:34:09 EST 2015 | travishemen
I cannot find the copy I had. Hopefully Tushar can get you a copy.
Electronics Forum | Thu Dec 17 16:52:50 EST 2015 | ttheis
Thank you for the effort, Travis. Tushar was able to provide me a driver.
Electronics Forum | Thu Feb 25 21:31:41 EST 2021 | ttheis
Thanks for the feedback, Tushar.
Electronics Forum | Wed Dec 30 11:10:53 EST 2015 | ilavu
Tom, Mount one sensor at about 6 inch inside of the beginning of the oven conveyor and use its output as ready to accept the board signal. That 6 inch distance will give you timing and space between two boards entering in the oven. Tushar
Electronics Forum | Wed Dec 30 11:24:51 EST 2015 | ttheis
Hi Tushar, That is the conclusion that I was coming to before Gary's suggestion. I think a sensor will probably be the best solution but it is good to have options and back-up plans. Thanks everyone
Electronics Forum | Tue May 03 00:03:30 EDT 2016 | ermani9
Hi.. Tushar, We are located in Chandigarh (India). We have our calibration kit too. Even performed Calibration also. But could not proceed for programming. Tried a lot but failing..
Electronics Forum | Tue Dec 13 18:23:17 EST 2016 | CEE
Tushar, The Flex requires a 44316801 16 I/O PCB in the I/O toaster. We have these in stock and are here to help if needed.
Electronics Forum | Mon Nov 19 02:33:26 EST 2018 | davis
Hi Tushar, I used http://www.pcbnpi.com for over 2 years. They can provide PCB prototype, PCB assembly, and stencil service. Prices are affordable! Very professional and I can rely on them and they always come through. So I highly recommend to you!
Electronics Forum | Tue Jun 26 10:23:43 EDT 2018 | ilavu
This video does not show FlexJet head, It is Flex head with 4 spindle. We have about 5 GSM with flex and FlexJet head with OS/2 and 4 with Windows2K. If you need any help, I will be glad to help you. Tushar
Electronics Forum | Tue Oct 14 09:21:38 EDT 2014 | rgduval
Thanks, Tushar, we might give that a try. The only reason I'd lean away from it is because I've been able to determine that I can't get the nozzles to move down on head 2 in the manual screen (or move the theta). I may be chasing two problems, but,
