Electronics Forum | Fri Apr 20 08:41:56 EDT 2001 | jimlew
For those of you out there, like myself who are still using 2-d to measure paste ht, I have 2 questions. 1. Typically, what tolerance are you applying to your ht? +- 1 mil, or what? 2. Are you using metal squeegees, and if so, have you found that squ
Electronics Forum | Fri Apr 20 16:05:17 EDT 2001 | gcs
We always reduce side to side, EXAMPLE: 12 mil width reduced to .010". Do you guys check viscosity ? Also maybe your guys are appling to much pressure on the sqweegee blades.
Electronics Forum | Fri Apr 20 11:05:23 EDT 2001 | gcs
Just a bullet! My results are, .005" stencil thickness should measure between .0055" - .006" if your pressure is correct, metal blades and snap-off is set up correctly. Do you have aperture reductions at the QFP locations "typicial industry standard
Electronics Forum | Fri Apr 20 15:27:00 EDT 2001 | jimlew
We do some aperture reductions - but it's not the 10% i'm accustomed to. Looks like it should be more than we currently do (I think we do 10% of length, but no width). Don't think we have a slumping problem, and we're not doing snap-off, only contact
Electronics Forum | Tue Oct 12 10:24:50 EDT 1999 | Jose RG
Hi, We are in the way to evaluate different solder pastes, improve our solder paste incoming inspection steps, re-define our stencil requirements and the following questions are open. Two questions, 1- Is anybody using/requiring 1000 Kcps or more
Electronics Forum | Tue Oct 12 11:47:51 EDT 1999 | Jose RG
Hi, We are in the process of evaluate our solder paste,incoming inspection over the solder paste, stencil requirments: 1- Is anybody using/requiring 1000 Kcps or more on viscosity to your solder paste provider ? Why ?? 2- Is anybody using step stenc
Electronics Forum | Tue Oct 12 22:22:34 EDT 1999 | se
| Hi, | We are in the process of evaluate our solder paste,incoming inspection over the solder paste, stencil requirments: | | 1- Is anybody using/requiring 1000 Kcps or more on viscosity to your solder paste provider ? Why ?? | 2- Is anybody using
Electronics Forum | Wed Sep 18 12:31:16 EDT 2002 | dragonslayr
My suggestion is to conduct a Design For Manufacturing (DFM)study on the assembly in question. Pay particular attention to the pad sizes, component lead dimensions and satisfy yourself that those two factors are correct. Given that pads match compone
Electronics Forum | Tue Aug 01 19:52:19 EDT 2006 | darby
If your frame size is 730mm x 730mm then you can't move it left or right. If it smaller than that then the frame adapter will give you more leeway. I am not too sure by what you mean by "If I had a 6" board, and a stencil with cut-outs for both side
| 1 |
